Home > Products > Electronics & Electricity > Electronic Instrument > Test Bench

It is used to measure the MFR value of the melt flow rate of various plastics and resins when they pass a certain temperature and load in a viscous flow state, and pass through a standard die every 10 minutes. It is suitable for polycarbonate, polyarylsulfone, fluoroplastic, nylon and other engineering plastics with high melting temperature, and also suitable for plastics with low melting temperature such as polyethylene (PE), polystyrene (PS), polypropylene (PP), ABS resin, polyoxymethylene (POM), polycarbonate (PC) resin etc.

Standards:

GB/T3682-2000 Thermoplastics Determination of melt flow rate and melt volume flow rate
ISO 1133:1997 Thermoplastics Determination of melt mass flow rate MFR and melt volume flow rate MVR
ASTM D1238 Standard Test Method for Determining the Melt Flow Rate of Thermoplastics by Extrusion Plastometer

FEATURE

1. English color LCD display

2. Manual automatic cutting

3. Dual temperature control system, more precise temperature control, and higher heating efficiency.

4. Double inlet sensor, more accurate upper and lower temperature gradient, can be used independently, improve service life.

5. The barrel is nitrided by imported Hastelloy, and the die is made of carbon tungsten steel.

6. The insulation barrel is made of all sus304 stainless steel, which will not rust at high temperature for a long time.

7. Calculate the result automatically and print it out.

8. With USB interface, can be connected to computer.

SPECIFICATION