Home > Products > Industrial Supplies > Rubber & Plastics Machine

PC injection screw barrels

• Specification

Screw diameter: Ø12-300MM  L/D:18-24
Barrel diameter:  Ø25-500MM      Length:300-1000MM

• Material

38CrMoAlA(JIS SACM645)

Cr12MOV(JIS SKD-11) 
4Cr5MoSiV1(JIS SKD-61) 
42CrMo(AISI 4140)

9Cr18MoV
Stainless steel,etc.

• Parameter

Nitrided layer depth:0.50-0.80mm

Nitrided hardness: 900-1100HV

Nitrided brittleness: Less than 2 level

Surface roughness: Ra 0.4

Linearity of screw: 0.015mm

• Feature

PC screw barrel is good for plasticizing,exhaust,molding due to PC's big melt viscosity.And to prevent enlarge the screw load,the screw's rotation speed couldn't too higher,general control in 30~70r/min.

When extruding PC products, PC material could not be used more than  recycle three times,consumption should be around 20%.

So we need to choose single thread pitch,gradient compression type screw with check vavle. 
length to diameter ratio L/D is 18~24,compression ratio C/R is 1.8~2.2.