1) barrel material selection for 45 steel substrate, eight holes with two alloy bushings, wear-resistant alloy a-101 (Fe-Cr-Ni-B+Carbide) hardness HRC60-64, barrel length L=240mm/section.
2) section I tube for feeding tube, tenth section cylinder to cylinder of extruder, remaining closed shell of the cylinder.
3.2 soft water tank and the separation of the body, easy cleaning and maintenance
By melt thermal galvanic material melting temperature measuring, measuring material pressure with pressure sensors.
J, electrical control system
1, 3X380V, AC 50Hz.
2, the main electrical control components are Siemens products
3, the control button for France Schneider
4, twin screw motor DC motor power 75KW, double screw extruder speed adjusting device for the United Kingdom continental Governor
5, feeder speed adjusting device for the imported frequency conversion speed regulator
6, temperature controller adopts Japan RKC products, dual-channel intelligent, temperature control in each district.
7, pressure gauge range as 0~25Mpa
8, electromagnetic valve Italy imports solenoid valve CEME9313
9, heating controlled by the temperature-controlled table through the solid state relay
10, electrical control cabinet control include: temperature-controlled system; drive; interlocking control system
K, interlock control system
B, earnest auxiliary set
C, spare
Three, training and services
1, provide on-site installation guide
2, equipment at the scene deb ing test
3, responsible for the training of party a personnel site operation and maintenance training
4, equipment failure due to design or manufacturing quality provide one year free warranty, and long-term guaranteed spare parts supply.
5, long-term provision of technical advisory services
6, inside and outside the warranty period, for the parties to answer demand-side device fault notification, give a clear solution within 6 hours, if required for officers, should be responsible for maintena
Four, installation deb ing: unit after arrival, demand-side supply-side technical file allows installation in place, the supplier is commissioning officers to attend the demand side device installation site is responsible for commissioning and installation and commissioning. Demand side should have the test conditions. After the unit's normal operation, namely transfer, demand-side user acceptance report should be provided to the supplier. Material provided by the required party needed to test, test conditions dominated by demand-side, the parties agreed.
Five, technical one.
nce in less than 10 hours to the scene (not including travel time in the middle).
