Home > Products > Construction & Decoration > Building Steel & Structure

1.Introduction of steel grating:

   Steel grating is extremely versatile and can be used in a wide range of applications. Our metal gratings are manufactured from a special fully-killed steel that meets the requirements of good weldability and high load-bearing capacity.
 
2.Basic terms of steel grating:

 A)Bearing bars: Equally rolled flat bar to bear the main load

 B)Cross bars: The erung squre steel ( also called twisted steel ) or round bar which is

 orthogonalized with the bearing flat bars, the cross section shall not be less than

 20mm2.

 C)End bars: Finishing bar of same section as the bearing bar welded across the ends of

 the bearing bars also around cutouts and notches where these occur.

 D)Action of bars:The bars used to secure the position of the bearing bars are commonly designated as the cross

 bars. Cross bar profiles vary according to the method of assembly and material selected. As with bearing bars,

 cross bar spacing is measured as "on center" spacing. The customary cross bar spacing is 4" on center. On special

 order, 2" on center and other special spacings are also available.
 
3.Methods of assembly:

 Welded grating,Swaged pressure locked,Dovetail pressure locked,Riveted grating,
 
4.Use of steel grating:

 Flooring, stair treads, sun shades, drain covers, security screens , manhole covers, mezzanine flooring, earth

 mats, shelving, stanchions ( hand rails )