| Model: | JAT HM9010 |
|---|---|
| Brand: | access-controller |
| Origin: | Made In China |
| Category: | Security & Protection / Access Control System |
| Label: | 13.56 reader , RFID proximity card , Proximity reader |
| Price: |
-
|
| Min. Order: | - |
| Live Chat: | Last Online:24 Apr, 2015 |
125K Proximity card and 13.56M smart card Multi-card card reader
Introduction
HM9010 is125K proximtiy card and 13.56M smart card CSN reader, it is a solution that one reader can read the most common RFID card and smart proximity card with ISO1443A and ISo15693 protocol. It reads all 125KHZ proximity card and also13.56M standard card serial number and transmits it to the access control system using the common Wiegand interface. And it also reads mifare IC card and I-code , Tag-it RFID card CSN number. It is with wide input power range from 5-16VDC at 100mA( A linear regulator is recommended ) and reading distance is from 5 to10cm; HM9010 is with external LED and buzzer control function, and it has one special hold control line which is allow access controller host stop HM9010 from detecting card.
HM9010 is good solution for intergrating multi-card technology into one reader with lower cost.
Model Name: HM9010
Wiring:
Red : Vin
Black: Gnd
Green: Data0
White: Data1
Brown: LED
Blue: buzzer
Yellow: Hold
Specification
| waterproof, Full potting for outdoor access control system | |
| support card: 125K proximity and 13.56M smart card serial number, Mifare smart IC card 14443A, Desfire, I-code, Hi-tag | |
| Power requirements | 5-16VDC at 150 mA, A linear regulator is recommended |
| interface | wiegand |
| Reader range | 5-10cm |
| Frequency | 125KHz + 13.56MHz |
| Operation temperature | -30 C to +60 C |
| operation humidity | 5%-95% relative humidity non-condensing |
| Audio/Visual Indication | Green & Red and Buzzer signal output |
| Dimension | 105 x 45 x 22 ( mm ) |
| cable length | 250mm |
| Weight | 150gram |
LED/Buzzer function description
LED function: The LED color is normally RED. It starts with 1 green flash on power up the reader and remains RED. When a proximity or other RFID proximity card is presented to the reader, The LED will momentarily flash green,this indicates that iclass card or RFID card was read properly by the reader. When the LED control signal is activated by access controller, the LED changes to green. The LED control signal is provided by the access control panel to control the reader LED state.
Beeper Function: Power up the reader, the beeper will activate 1 time. When aproxomity card or RFID proximity card is presented to the reader, a short beep will be emitted. This indicates that the card was read properly by the reader
Buzzer control line: when it is activated by access controller, buzzer will sound continually till the line is released to high by access controller or access control panel.
Green LED control line: when it is activated by access controller , Green LED will be on till the line is released to high by access controller or access control panel.
Hold function: when this line is activated, ( low by access controller HOST ) the reader will stop detecting proximity card until the line is released.( high or released by access controller or access control panel).
