Home > Products > Electronics & Electricity > Optical Fiber, Cable & Wire > Optical Fiber

Characteristics：

☆ Matched with Bulls polishing fixture and no need to adjust the equipment, Except for the influence of parts and process, the 3D can reach 100% pass rate and the offset is mainly concentrated within 35UM.

☆ Optimized polishing trace can reach more better quality of end face and extent the service life of polishing film.

☆ The product is easy to changing-over, there is no need to adjust the equipment when changing over product.(for example, SC and LC changing over),Can reach the same quality level.

☆ Support greater load at the same time.The machine can driver 36 SC connectors and the efficiency can be increased 50%-100% matched with patent fixture of Bulls.

☆ Support 10 kinds of polishing program and each kind support 5 steps. Select the program through buttons which is very simple.

☆ Independent polishing compensation function, each polishing step can keep independent polishing compensation parameters. Polishing compensation time can be started or closed independently according to requirements.

☆ Polishing speed (30-160rpm)and slow start time(0-15s)can be set independently for each step to ensure the maximum process flexibility and best product quality.

☆ Count the used quantity of polishing film for each step and current times of polishing film is good for process test and management.

☆ Can support Both Chinese and English operation interface.

Main parameters：

Overall Dimension: 220mmx320mmx285mm
Disc diameter: 129mm
Voltage: 220V AC, 2A Fuse
Power: 60W
Speed range: 30- 160rpm 
Slow start range: 0-15's
Time range: 0-900's 
Program capacity : 10 kind
Each program allows: 5 step

Note: Due to technical upgrade or other reasons, Bulls keeps optimize the specific parameter or adjust without prior notice.