Modified method of energy-saving burner
For the installation of energy-saving burner, use, need to be modified the original stove, and our products, scientific and rational design, makes it very easy to install! As long as the original burner can slightly improve it! Less than 10 minutes can be converted to finished! The modified method of introduction is as follows:
First, removal of the original water plate cooker, burner, electronic switches with the wind on board two of the outlet nozzle to discharge, and switch into a straight line of fire for small eyes, the left or the right eye for the fire.
Two, the wrench (or pliers pipefish, etc.), tap the cooker under the iron tube, iron tube to allow attachment within the cinder, rust loose material down, add some gas, to the cinder, debris, etc. from rust. The purpose of this step is to prevent the cinder, rust and other debris were about to be installed to plug the hole nozzle.
Three, the replacement of single-tube energy-saving burner will fire with a screwdriver to close eyes (must be raw at Riga with thread to prevent leakage. With raw materials, plumbing materials on sale in stores), will be connected to gas and energy-saving switch straight into the hands of the stomata (the small fire eyes) up, and tightening (to add Health and belt). If the replacement energy-efficient twin-tube are, as long as the order put the nozzle in accordance with the size of stove, fire up your eyes to install separately. It is worth noting that the need to distinguish between good large and small fire eyes. Note: Do not install the screw too hard to prevent the breakdown of Edison.
Four, well after the installation, in accordance with the use of cooking at home means (a round pan or pot), adjust the level of burner, generally 1.5-3 cm from the bottom of the pot is best for them.
Friday, testing whether the leak: a lighter hand inspection, test, control the other hand, the total gas bottle valve in order to prevent the event, turn off gas supply in time.
Six, has heard such as smell and found that leakage should be a total turn off the valve immediately to eliminate the appearance of fire all at the same time open the doors and windows, and then check the reason for leakage.
Seven, after completion of the above work, you can use, but to look at the situation of the combustion burner, when the burner lit when the normal 5 seconds, 3-burner surface should be flushed red, if red is slow or Long time is not red, should put pressure gas cylinders that can be raised in order to achieve the desired energy-saving effect.
