| Model: | - |
|---|---|
| Brand: | - |
| Origin: | Made In China |
| Category: | Electronics & Electricity / Telecommunication & Broadcasting / GPS |
| Label: | bluetooth , gps receiver |
| Price: |
-
|
| Min. Order: | - |
| Live Chat: | Last Online:10 May, 2007 |
| BT-50: high technology product which includes the most advanced Bluetooth and GPS technology. With Bluetooth technology, you can get GPS data , position and navigation on your smart mobile phone, PDA, PC, desktop computer, etc.
Product Features 1. Low power consumption: 95mA 2. Battery Embedded Li-Polymer Battery 900mAh (20 hours), Compatible with rechargeable Li-polymer Battery, charger of Nokia mobile phone (N70 and so on ) 3. Support Bluetooth 1.2 protocol Class 2 4. High sensitivity and performance GPS chipset, 16 parallel satellite-tracking channels 5. Compatible with Bluetooth Serial Port Profile (SPP) completely. 6. 3 LED indicator lights show the state of Bluetooth, GPS, and charge 7. Support NMEA-0183 data protocol baud rate 9600 bps 8. Portable and humanize design. Technology Index General GPS Chip NEMERIX GPS(chip?s)Module Receive Frequency L1, 1575.42MHZ C/A code 1.023MHZ Channels 16 channels all in view tracking Antenna(internal) Built-in low noise Sensitivity Hunting -147dBm Tracing -152dBm Receiver Accuracy Position 7 meters CEP 90%, 3 meters CEP 50% (SA close) Velocity 0.1m/sec, with SA Time ±100ns synchronized to GPS time Acquisition Time Hot start ≤12 sec, average Warm start ≤38 sec, average Cold start ≤60 sec, average Limitations Altitude Limit up to 10,000 meters Velocity Limit < 515 meters/sec. Acceleration Limit up to 4G Jerk 20m/sec GPS protocol NMEA-0183 ASIC protocol NMEA 0183 (V3.0) - GGA, GSA, GSV, RMC(default); VTG, GLL (optional) Baud rate 9600bps, Data bit: 8, Stop bit: 1 Bluetooth Index Bluetooth Criteria V1.2 Launch Power Class 2(up to 4dBm) Receive Sensitivity -80 dBm Communication Distance 10 meters typical Communication Profile Serial Port Profile (SPP) Power Consumption Operation Current 45mA typical Operation Voltage 3.7V Charging Voltage 5.7V Datum WGS-84(or by demand) Battery Charging Time 2.5 hours typical Operation Time 20 hours tracing after fully charged Environment Condition Operation Temperature -20° C to +60° C Storage Temperature -20° C to +85° C Relative Humidity 5% to 90% non-condensing Hardware Characteristic 1. Dimension 72.8(L)?45.8(W) ?18.8(H)mm 2.87(L)?1.78(W) ?0.743(H)inch 2. Package Includes BS-50 GPS?1 Car Charger?1 (12V input 5.7 output.) Travel Charger?1 Manual?1 Rechargeable Li-polymer battery ?1 3. LED State LED State Description Green LED Light on GPS haven?t finished positioning Quick flash GPS have finished positioning Blue LED Quick flash Bluetooth didn?t construct connection Slow flash Bluetooth have construct connection Red LED Light on Under charging Light off Charge finished Note: How to use the battery effectively Plug the charger into a standard ac outlet Insert the charger output plug into the round connector at the side face of the receiver. If the battery is completely charged, the red indicator on the top of receiver will be lighted off. Important battery information Important: The receiver is powered by a rechargeable battery. Never use any charger or battery which is damaged. The battery can be charged and discharged hundreds of times but it will eventually wear out . When the operating time (talk-time and stand by time) is noticeably shorter than normal ,it is time to buy a new battery. PROLONG THE BATTERY LIFE Use the following guidelines to obtain the best performance from your battery: Use the battery until it is fully discharged. With the receiver turned off, charge your new battery for 8 hours at the first time and 3~4 hours at the second and third time. Note that a new battery?s full performance is achieved only after three complete charge and discharge cycles. Battery operation time may be less than the estimated times during the first charges. This condition is normal. If the battery is completely empty, it may need to recharge a few minutes before you can switch the receiver on, a few minutes before you can switch the receiver on. Important: when the phone?s battery is fully charged, be sure to disconnect the charger from the phone and the outlet |
