Home > Products > Electronics & Electricity > Electronic Instrument > Other Electronic Instrument

The UV-Probe Integrator is a self-contained, high quality UV measuring instrument. It is designed to measure and display UV energy in mW/cm2. An additional function is the scan of the peak value of UV-energy in mW/cm2 and to measure the UV dose in mJ/cm2 within a pre-set period of 30 seconds.

In the standard version it is equipped with one UV sensor for the measuring of:


Full UV spectral area 230 – 400 nm (Standard)

Due to its UV sensor and the integrated microprocessor the UV-Probe Integrator can measure and display the peak UV-energy of the full UV spectrum (mW/cm2).
Additionally, this UV-Probe Integrator is calculating the UV-dosage (mJ/cm2) of the UV energy supplied during the time of exposure of one measuring cycle. The UV-dosage is calculated as the total Integral of UV-dosage over the full UV spectral bands.

The removable, probe-type sensor is connected to the base unit by a cable of approx. 1 meter (40”) length. In the function “Direct” the actual UV-energy in mW/cm2 supplied to the sensor is measured. The function “Scan” will start a 30 second measuring cycle of both, UV-energy and UV-dose. After completion of the measuring cycle the measuring results can be scrolled through on the built in 2 x 16 digit LCD display.
A special AUTO-OFF feature that turns off the unit automatically after one minute serves as energy saving and extension of the battery service life.


The UV-Probe Integrator is available in five different measuring ranges:


(Please state upon order)

Item 28.1.1 UV-Probe Integrator, Type 1 UV-Diazo 350 – 460 nm
Item 28.1.2 UV-Probe Integrator, Type 2 UV-A 315 – 410 nm
Item 28.1.3 UV-Probe Integrator, Type 3 UV 230 – 400 nm (STD)
Item 28.1.4 UV-Probe Integrator, Type 4 UV-B 280 – 315 nm
Item 28.1.5 UV-Probe Integrator, Type 5 UV-C 230 – 280 nm