|Category:||Electronics & Electricity / Battery, Storage Battery & Charger|
|Label:||Intelligent Charger , Battery Charger , Charger|
|Min. Order:||10 pc|
36V 2A Dynamic Power Battery Charger
|Output: 41.4V 2.0A|
|Charge Process: MCU Control, With Recovery Function|
|Charger Indicator: With 5 LEDs to Display Battery Fuel Gauge|
|Output Protections: Short-circuit, Reverse Polarity...|
|Safety Approval: CE cUL|
|Size: 170 x 71 x 41mm|
|Suit for Battery: 36 Volt 4~15Ah Lead-Acid Battery Charger|
G100-36A is a main member of digital-chargers from Green Digital Power-tech Co., Ltd. It represents today's new technology for lead-acid type battery charging. G100-36A programmed four auto stages (Ud-Im-Uo-Up) charging process,It is designed for all kinds of 36V lead-acid battery, such as SLA, AGM and Gel battery. Stage "Im" will give bulk current charging. Then, "Uo" stage is followed, the output voltage is limited on 44.1V( for 36V battery); When the battery is nearly full, stage"Up" will turn on duty. At this stage, the battery is charged completely and the charger give some pulse to maintenance the battery.
Further, G100 can display the charging process, indicate the battery capacity from 25% to 100% timely. This is helpful for user.
For more safety, G100 will inter protection mode when the battery polarity reversed or the output connectors shorted.
Specification for G100-36A
|Input Voltage||100-240VAC, 50-60Hz|
|Back current drain||1.3mA|
|Bulk charge current||5.5A±8%||2.8A±8%||1.8A±8%||1.7A±8%|
|Cooling||Natural convection. Do not cover the charger.|
|Charge principle||4 stages: Ud-I-Uo-Up (Note: For 24V and 36V type, Ud is absent)|
|Battery type||All types of 36V lead-acid batteries.( SLA, Gel, AGM.)|
|Size||170 x 71 x 51mm|
|Enclosure||IP54 (Dust protected, Water splashing resistance)|
How to use:
1. Connect the AC cord to the socket, The "power" lamp will light on solid.
2. Connect positive charger clip (red) to positive battery terminal, the black clip to negative. (You can use other dc plugs to connect battery), the "25%~100%" lamps will light on flowing. If the battery polarity reversed or output shorted, all lamps will flashing, please check the setup.
3. Depend on the charged capacity, 25%~100% lamps will lights up solid sequence, until the battery is fully charged. Then you can power off the charger and disconnect the battery or you can charge a new battery if you need.
The table shows the duration of 80% state charged for an empty battery.
|12||Not recommend||5 hours||7 hours|
|22||5 hours||9 hours||12 hours|
|40||9 hours||14 hours||20 hours|
|80||16 hours||Not recommend||Not recommend|
|Payment Terms:||TT, L/C, D/A,D/P|