|Origin:||Made In China|
|Category:||Toys / Model Toys|
|Label:||rc glider , rc airplane , rc plane model|
|Min. Order:||5 pc|
RCRCM 2900mm F3F Glider – Strega
The Strega makes for an excellent F3F sport model. If looking for something that's fast and can maintain energy on it's turns, then Strega is for you!! The elliptical planform supports a very large speed envelope, with no nasty habits at low speed. The wing is two part, with a carbon joiner and a removable V-Tail. The wings and fuse are ready for your plug and play multiplex setup, allowing for super fast setups at the field or slope. The fit and finish of the Strega is similar to much more expensive models, yet it still has an industry leading level of pre-assembly!
Supported by a large carbon wing joiner, the plug-in wings are of elliptical plan form which has been optimized to give a compromise between good lift distribution without the attendant tip stalling behavior sometimes seen in truly elliptical plan forms. Fin and tailplane sections are also of advanced symmetrical design and have no drag bucket at any speed. Glider for experienced pilots, Strega offers outstanding performance and excellent thermal flight qualities. It is also able to pick up speed, to convince you. It is able to fly in virtually all conditions and it is equipped with ailerons, flaps and a motor. All surfaces are pre-painted in the molds for flawless external finish. The whole model uses live hinges and wipers for control surfaces. From its super-efficient V-Tail, to its new larger diameter nose area, this little guy was built for fun!
Flying Weight: N/A
Empty Weight: Fiberglass+Carbon Standard Version:1610g
Full Carbon Version: 1720g
CG：center of Gravity 102-110 mm from leading edge
Servos for wings KST DS125MG*4
Servos for fuselage KST DS215MG*2
Required Battery 4.8-6V