Home > Products > Chemicals > Adhesives & Sealants

Features:

State of granular

The color white

Viscosity (1600 c) about 50000 mpa. About 25000 s 1800 c

Softening point is about 850 c

Second, the conditions of use

The material moisture content % 8 to 10

At room temperature and material thermometer 0 c 15 or more

Roller temperature 0 c. 130-160

Conveyor speed 8-20 m/min

Kg/cm2 pressure pressure for 3 to 5

Coating weight 180-250 g/m2 (need to adjust according to actual condition)

In the end use of the specific conditions of please determine after deb ing

Three, use

KD - 8650 is suitable for various types of sealing side machine and coating machine, applicable material such as wood chips, melamine impregnated paper, PVC, ABS edge banding material such as particieboard or MDF board edge banding, such as sealing side or coated on the man-made board. .

Fourth, matters needing attention

1. Joint sealing side parts to clean, do not have any dust and oil pollution, pressing to seal, avoid to produce a certain pressure is insufficient or not average. Regularly check the gluing roller surface, clear impurities, ensure the glue evenly.

2. To check the temperature measurement of the installed on the machine, has the temperature error.

3. Should be coated uniformly, coating weight will be adjusted because different materials, and the quantity is little strength is insufficient, will cause the sealing side quantities can cause gum line, the machinery and material surface and dirty.

4. When the room temperature is below 150 c, it is s ested that the local heat sealing side face and sealing side material, to ensure cementing quality. Work temperature should be reduced by 30-400 - c

5. Feed speed can't less than 8 m/min, avoid the not when pressure has cooled off, if it is necessary to work under low feeding speed, must adjust temperature increase, laminating material should warm up first.

6.25 kg/bag, stored in a dry or shade

7. Hot melt adhesive to be sealed storage, not use up back to avoid contamination and moisture absorption

In the end use of the specific conditions of please determine after deb ing

Three, use

KD - 8660 is suitable for various types of sealing side machine and coating machine, applicable material such as wood chips, melamine impregnated paper, PVC, ABS edge banding material such as particieboard or MDF board edge banding, such as sealing side or coated on the man-made board.

Fourth, matters needing attention

1. Joint sealing side parts to clean, do not have any dust and oil pollution, pressing to seal, avoid to produce a certain pressure is insufficient or not average. Regularly check the gluing roller surface, clear impurities, ensure the glue evenly.

2. To check the temperature measurement of the installed on the machine, has the temperature error.

3. Should be coated uniformly, coating weight will be adjusted because different materials, and the quantity is little strength is insufficient, will cause the sealing side quantities can cause gum line, the machinery and material surface and dirty.

4. When the room temperature is below 150 c, it is s ested that the local heat sealing side face and sealing side material, to ensure cementing quality. Work temperature should be reduced by 30-400 - c

5. Feed speed can't less than 8 m/min, avoid the not when pressure has cooled off, if it is necessary to work under low feeding speed, must adjust temperature increase, laminating material should warm up first.

6.25 kg/bag, stored in a dry or shade

7. Hot melt adhesive to be sealed storage, not use up back to avoid contamination and moisture absorption