Home > Products > Industrial Supplies > Machinery > Filters

Series EOS base oil and diesel oil from used motor oil recycle equipment

Product Application
This equipment EOS is applicable for recycling engine oil, gear oil, hydraulic oil, form oil, rail oil, compressor oil,
vacuum pump oil, axle oil, slideway oil, bearing oil, turbine oil, cylinder oil, drawing oil, conduction oil, quenching
oil, insulation oil and rolling oil in industries of petroleum, chemical, cement, metallurgy, mining, electricity, shipbuilding,
 machinery, military, rubber, instrumentation, transportation, building materials, paper making etc. It is mainly for
the waste engine oil in various automobile repair plants and 4S stores, floating mixed oils and light coal tar oil which
are from various industrial and mining enterprises and flow into sewer, schizolytic crude oils of straws and firewood.
After distillation classification treatment, the oil is processed to base oil and diesel. It will never reverse color.

Product Features

1. Gasification reaction still: designed regarding the production scale; equipped inside with material adding preheating tube;heat source adopts infrared electrical heater or coal etc.
2. Catalytic tower: made regarding production scale; with clapboards inside and downside the tower; with highly efficient chemical filler upside which is adjusted regarding the season and customer requirement.
3. Cooler: cooling water enters from the bottom and flows out of the top.
4. Oil water separator: adopts the principle that water has bigger density than oil to layered and separately discharged oil and water.
5. Oil gas separator: recycle the non-condensable gases into furnace to be burned or purified and then discharged out. It both resolves environment protection problem and saves fuel.
6. Fire arrester: it is actually a liquid phase epitaxy seal which contains water downside. Non-condensable gases enter into the water and then come out; then the gases are sent through gas pipeline into the
 furnace to be burned, which can prevent gases to flow back to avoid fire disaster caused by backfire.
7. Preheating tank: preheat the material by the flue temperature to remove water.

Technical Parameter

Working principle and flow chart

We adopt the technology of different material’s molecular motion is different to achieve the separation of substances
Firstly, pre filter the oil by removal of big particulates in oil, and then pumped into distillation tower and heated. During
the process, the molecular which is distilled enough energy escape from the molecular level. Between Less than the
mean free path of molecules and larger than the light weight of the molecular mean free path, a condenser provided
at the surface, so that the light molecules is condensed continuously. In this way, extract the desired component from
the waste oil (The process can be carried out at temperatures far below the boiling point, low pressure distillation,not
easily oxidized. Lighter molecules escape from the surface , almost without collisions to reach the condensing surface
, so the heating time is very short. It is high storage rate of volatile and high heat-sensitive material).
The distilled oil is storage in oil tank. Through dehydration, degasification process to remove the dissolved water and
dissolved gas completely. Then the oil is pumped into secondary filter and fine filter to remove tiny particulate.
If the out oil has not yet reached the color and transparency as you required , It can be pumped into the reactor through
the oil out pump , adding the adsorbent material by physical method to discolor and then through a filter press to
separate liquid and solid. Then filtered by secondary and fine filter again. Finally, we get good new oil.