Home > Products > Security & Protection > Other Security & Protection

Product Description
1 power supply: solar cell (Dan Jinggui) 2.5V/120MA
2 energy storage devices: rechargeable battery NI-MH 1.2V/800MAH high temperature battery
3 working hours: Full recharging for 8hours and working in 120hours constantly
4 load capacity:over 20T
5 display: Ultra bright diameter 5mm;  6pcs(double side)
6 working mode: flashing (2Hz + 20%) and constant
7 rev control light intensity: positive light is less than 500Lux
8 visual distance: over 500 meters
9 service life: 3-5 years

Product Feature
1 solar power supply, energy saving and environmental protection, convenient installation, working mode automatically start lighting at night
Two, installation method
1 installed on both sides of the road, pay attention to whether spike solar panels can be sunlight
2 installation useful glue and nail spike installed by spike

Application for road stud

1. Dangerous blind corners and sharp-curves, black spots and poorly lit areas.

2. Areas with unpredictable weather conditions (coastal roads, foggy areas, wet and rainy regions, etc.).
3. Joint intersections, on and off ramps, center lines and dividers, entrance warnings, carpool lanes, bridges, cross and side walks
4. Guidance lines, traffic islands, roundabouts and mountain roads.oad
5. Taxiways at airports, bike and pedestrian lanes, aboard ships and watercrafts.

How to install

1.Mix the glue first

2.Positioning :Road stud install place must to be flat ,dry ,clean ,seamless

3.Stick with glue:using the proper quantity glue, sticked on the ground firm, after installation, please turn the road stud left and right once again to ensure the road studs paste on the road uniform

4.Road closures:Must be 6 hours of road closures to ensure the glue curing time