Home > Products > Electronics & Electricity > Other Electrical & Electronic

PT series are two channel anolog power amplifier,including eight model:PT-4(250W*2), PT-6(400W*2), PT-9(600W*2), PT-11(800W*2), PT-15(1000W*2), PT-18(1200W*2), PT-20(1500W*2)

PT-4 2 channel anolog power amplifier

1 Power supply design

Each equipment includes independent logic high rate of power supply,which can control electrical circuit to adjust power output and voltage from time to time, and to respond the request of signal and load,so it can  get the best power match under the wide range of load,so to ensure the power amplifier will not be overheating.

2 Power output grade

Adopt the balance output circuit,the same as fully symmetrical Bridge Road:compared with the normal single end of land output circuit,the same work voltage can generate the output power in 4 times,that is to say,in order to get the same output power,the work power voltage of power amplifier is much lower thannormal OCL model.The output power tube is with wide safety work area under the condition of low voltage,so it is with higher power and reliability  compared with normal OCL output  model. Most importantly, The distortion of it is much Lower and can  output better tone quality.

3 Sign Voltage Range

There is a limited voltage device within each input channel.By checking the output sign and controlling the input sign,so the power amplifier output will not be at the state of clipping in long time,and can protect the speaker.It can automatically control the input sign when the power amplifier is overheat,so can reduce the heat and keep safety.

4 Perfect protection function

Power amplifier provides various protecting function, such as .direct current protection,internal stoppage protection,input overload protection,filter of radio frequency distraction,output short circuit protection,mismatching load and high frequency overload protection, radiator and over temperature protection for radiator and transformer,over electricity protection.And the over temperature protection for output electricity is achieved by gradually lower the output signal.Only when the temperature keeps rising to the extremity,can it cut off the output electricity supply of this channel,so avoid the stop of play.

5 Heat dissipation system

There is an independent heat dissipation system for each channel,two groups of nonpolar speed adjusted Fan.The sealed air go through the radiator to strengthen the effect of heat dissipation,and at the same time,avoid the the dust and smog of stage to pollute the circuit board to ensure the equipment is in good working condition,and the temperature can get balance in some

ranges.

Model                                       PT-4

 8Ω   Stereo Power                         2×250W

 4Ω   Stereo Power                         2×400W

 8Ω   Bridged Mono                         1200W

Input   Impedance                           >20K/>10K

Frequency   response                        20Hz-20KHz

THD+N(Rated   Power,4Ω/KHz)%               0.05%

Signal   Noise Ration(dB)                   -105dB

Degree   separation                         -60dB

Input   Connectors                          XLR

Output   Connectors            Speakon&touch-proof   binding posts

Power   Requirement                         220V-240V,50-60Hz

conformation                           Steel   and aluminum chassis

Airframe   Dimension                         88×483×430mm

Net   Weight                                 16kg