Home > Products > Security & Protection > Burglarproof

cell phone security display holder with alarm
professional supplier for open display
Function:
1) Host Base with Charging Function, Charging monthly , Repeated use.
2)Display Charging Function apply to : Mobile Phone
3)Disconnection Alarm Function:Three Contacts disconnection alarm
4)Low Voltage Alarm Function :Voltage Less 3.3V Alarm ,remind the charging
5)Short Circuit Alarm Function : circuit is short-circuited ,automatic alarm
6)Infrared Remote Control Function : Remote Start and Disarm the Alarm.
7)Installation Method : Double ways in 3mm adhesive or use screws tighten.
Products installation
1.Clean the display case, then turn on switch on the bottom of Security alarm holder for mobile host, adhere the bottom of the anti-theft frame with adhesive tape to the exhibit cabinet. Or use two anti-theft screws to connect the cabinet frame and tighten the exhibition (open the screw hole cover firstly)
2.Connect the charger of Security alarm holder for mobile with the alarm host, the other end into the power socket in preparation for a fixed monthly charge.
3.Tear off the adhesive tape from the Anti-Theft Terminal product for display and paste exhibit’s back fastened
4.Tear off adhesive from the sensor probe, stick tight with the obverse of the product
5.Take out the Infrared remote control board , tear off the battery insulation sheet underneath. Press the ON key , the host switch on ,enter the preset alarm status
6.The installation is set up