|Category:||Transportation / Car Accessories / Auto Repair Tools|
|Label:||tyre repair kit , emergency tool kit , tyre sealer|
|Min. Order:||1000 pc|
1.Insert cigarette lighter of inflator into cigarette lighter socket,or clip car positive and negative electrode by crocodile clip,pay attention to not inverse(red is positive electrode,black is negative electrode )
2.Start the engine open the switch
3.Connect the air cock to tire valve directly when inflating
4.Note the dial indicators of pressure gauge when inflating,turn off the switch after up to the rated value,pull the air cock(air pressure rated value usually is 28-35PSI)
Tire sealant instructions
1、First find how many holes on the tire ,check how much tire sealant probably need.
2、Remove the tire valve to the location of the clockwise 4 or 8.
3、Shake the tire sealant fully,rotate the nut,cut off the top of bottle appropriate place.
4、Remove the valve needle with valve core removal, put the mouth of bottle into tire valve,then,squeeze the bottle,pull the liquid into tire.
5、Screw the needle of valve on,blow up the tire.Turn the tire running 2 minutes.
6、After pressure test up to normal,it can be automatically repaired.We can drive safely.
Valve core removal instructions
1.Rotate the tire valve cap off
2.Use the valve core removal aim to tire valve and insert into it,then rotate until valve core off.
Tire repair tools instruction :
1.Use a spray bottle to confirm the repair site, mark it.
2.Remove the prickled part with tire repair tools by inserting it through the hole of the prickled part. Repeated rotation around the hole cleaning, confirm no dust.
3. Select suitable tire seal specifications, placed on the special tool, pull out special cone at the same time, quickly use tire seal inserted into the hole, fixed appropriate position, rotate 360 degrees and pull out the special tool.
Cut off the extra tire seal from tyre surface, guaranteed the tire appearance.
During operating, it is strictly prohibited to tire seal and special tool surface stained with oil contamination.
6.use liquid soap or detergent diluted solution to this site to observe if there are bubbles. If there is no bubbles that successfully repaired.
Use the special end of screwdriver aim to the top of the screw,fixate,then start to rotate handle
Tire repair knife instructions
Used for cut the extra seal after repair tire.
Clyburn spanner instructions
For tightening and loosening screws or nuts. When turning the handle clockwise to tighten. Fitted with a brace on the square sleeve. When the handle is pulled in the opposite direction, it stays in the beveled ratchet teeth slide, which screws or nuts not follow inverted. If you need to loosen the screws or nuts, simply flip the ratchet wrench to rotate in a counterclockwise direction.
Pincer pliers Instructions
For pulling out a tire wound rubbish (such as: nails, iron bars, broken glass, etc.), or for dismantling tires.