Home > Products > Electronics & Electricity > Magnetic Materials

Push pull type pipe explosion-proof electromagnet
This product is specially designed for the structure design of explosion-proof environment, all products are explosion-proof structure of GB GB3836 the requirements of the design, including the outlet position, driving position, the reset position.
The 1 principle:
Node for low voltage products, products in the slide rod action, after powrefailure automatic reset slide rod products. This product is a push type structure, in addition, the product itself also has the anti power cuts, when there is a power failure, push and pull type circular tube explosion-proof electromagnet slide bar is still used manual work.
2 products of electrical parameters:
Voltage: can choose between 6-220V, the general use of low voltage DC power supply to work.
Power: electricity rate about the power and the product, as shown below:
Current: current = power / voltage, so choose the power voltage, then the size determines the current size of the product, so the need to pay particular attention to whether the size of the current can make the power supply circuit load.
3 push and pull type pipe explosion-proof electromagnet definition:
Also called tubular electromagnet, tubular solenoid, push type refers to the product when the power is switched on the sliding rod pull in, using the sliding roof bar on the push pull type object, refers to the product, energized when the sliding rod pulling objects.
According to the circular pipe with different diameter sizes, generated power stroke, electrical parameters are different, the current market minimum tube diameter for our production, the diameter of 6.5mm, maximum temporary not limited. Our biggest done 500mm diameter. Because the use of sealed package, used to waterproof electronic products or equipment.
4 selection:
A: to determine the need to push and pull type pipe explosion-proof electromagnet to push or pull the object, as mentioned above, the push type refers to the product a power push objects pull refers to products electrifying pulling objects. Respectively, the pull and push:
Pull type: (right not rod)
Push type: (on the right there is a top rod)
B: to determine the need to push and pull the distance of objects, there will be an object from A to B at the distance.
C: to determine the need to move the power of objects, from A to start moving to force, and then moved to the B end of the whole process, the maximum force required.
D: to determine the circuit voltage can be supplied to the electromagnets, DC or AC.
E: to determine the current load circuit.
F: determine the need for the electromagnet working time, rest time.
5 other push-pull tube explosion-proof electromagnet:
Push pull type pipe explosion-proof electromagnet