Wall Mounted Magnetic cell mobile phone display holder with charger alarm
Technical parameter of the Security Display Stand for Mobile Phone:
- 1.Product size: 90*50*35mm
- 2: Single weight:250g
- 3:Main material :ABS
- 4.Shell Color: pearl white
- 5.Internal Battery type: 3.7V rechargeable lithium battery.
- 6.External power adapter: DC5V 1000MA
- 7.Battery Standby Time: 50hours
- 8.Charge indicator: charging in red , full in green
- 9.Alarm sound: 105DB.
- 10.Alarm indication: LED red flashes.
How does the Security Display Stand for Mobile Phone work for security?
- 1:Three Contacts disconnection alarm.
- 2:Short Circuit Alarm Function
- 3:Remote Start and Disarm the Alarm.
- 4:Password function,Change the password freely
How does the Security Display Stand for Mobile Phone work for charging?
- 1:Phone Charging and security by one cable.
- 2: Applies for any brand mobile phone ,cable interface optional
- 3: GB/EURO/ANSI/BS power plug available.
What accessories does the Security Display Stand for Mobile Phone have?
- 1.host base (rechargeable lithium battery inside)
- 2, Aalarm sensor probe(with a magnetic back, paste 3M adhesive. Extension cords )
- 3.harger and USB charging cable
- 4, Cell phone charging adapter cable
- 5, Remote control
- 6 Operation Manual
- 7 Additional 3M adhesive and screws
How to install the Security Display Stand for Mobile Phone?
- 1.Clean the display case, then turn on switch on the bottom of Hot security cellphone /mobile phone display holder /stand with charging and alarm host, adhere the bottom of the anti-theft frame with 3M adhesive tape to the exhibit cabinet. Or use two anti-theft screws to connect the cabinet frame and tighten the exhibition (open f the screw hole cover firstly)
- 2.Connect the charger of Hot security cellphone /mobile phone display holder /stand with charging and alarm with the alarm host,the other end into the power socket in preparation for a fixed monthly charge.
- 3.Tear off the 3 adhesive tapefrom the Anti-Theft Terminal product display and paste exhibit's back fastened
- 4.Tear off 3M adhesive from the sensor probe, stick tight with the obverse of the product
- 5.Take out the Infrared remote control board , tear off the battery insulation sheet underneath. Press the ON key , the host switch on ,enter the preset alarm status
- 6.The installation is set up
Are there any other photos of the Security Display Stand for Mobile
Send Inquiry to this Member
Related Products of this Company
This member assumes full responsibility for the content of this listing. DIYTrade accepts no responsibility whatsoever in respect of such content.
To report fraudulent or illegal content, please click here
China Suppliers Quick Searching: