Home > Products > Consumer Electronics & Lighting > Lighting > Lighting Fixtures

8-20W led non isolated fluorescent lamp driving power YL-RF820D

8-20W led non isolatedfluorescent lamp driving YL-RF820D,external 2A600V Shilan micro MOS tube,input of wide voltage,small volume,easy to add T8,T10 tube,220V input PFC can reach more than 0.95,compatible with the inductor rectifier.

Product name:
8-20W led non isolated fluorescent lamp driving power YL-RF820D
input voltage:AC100-265V
Conversion efficiency:≥90%    
Protection characteristics:Output overload/output overvoltage/short/over temperature
The product model:YL-RF820D    
The output voltage:36-80V
Power factor:≥0.95 
Output power:8-20W
Output current:230-240mA
Size and shape:125mm*16.5mm*9mm
Service life:≥30000h

Product Features:
Universal AC input 175-265V AC range
Characteristics: 
short circuit protection/load/overload/overvoltage
Jing Feng PB2832A,built-in 2AMO tube
Emerald 5000 hours electrolysis,no stroboscopic
High accuracy high price of small volume
100% full load burn-in test

Note:
1.All parameters NOT specially mentioned are measured at 230VAC input, rated and 25℃ of ambient temperature.
2.The Accuracy is the total Accuracy which Comprises the Line Regulation ,Load Regulation and Error.
3.Constant Current Mode Can Apply Only to the LED and relevant industry.
4.Ripple & Noise are measured at 20MHz of bandwidth by using a 300mm twisted pair-wire terminated with a 0.1uf & 47 uf parallel capacitor.

Instructions for use:
This product at both ends, one end is the AC input terminal, wherein one end is the input "N" end; the other end is "L" end of input. The other end of the DC output,
 DC output is negative, then "LED-"; the other end is connected with the DC output positive, "LED+".
1:the device power, please pay attention to the input, output the correct mounting;
2:in order to avoid the LED burn, please connect the DC output drive power;
3:when using this product please note the high security, and good anti shock measures.

The abnormal phenomenon and the corresponding treatment methods:
1.the power supply in the first device electrical connection, such as not bright or other corresponding phenomenon,please cut off the input AC and check the DC output 
has no bad contact or AC input has no bad contact;
2.in the device electrical connection, and the LED lamp is lit, but the output is abnormal, please cut off the input end of the AC check the DC output has no overload,
overload;
3.the product in the use of process in case of any questions or solve problems please communicate with our,feedback information, so as to enable us to provide more 
quality products and services.

(This article by the Yili photoelectric LED waterproof power supplier consolidation share).