Home > Products > Toys > Remote Control Toys

Application of ESC:

RC airplane (including fixed wing, helicopter)

Electrical performance parameters of ESC:

Input Voltage:2-6 cells LiPo batteries/5-18 cells NiMh batteries 

Continuous current output:100A

The maximum instantaneous current (10S):140A

BEC:SBEC/UBEC/OPTO

BEC output:5.5V/4A (SBEC), 5.5V/1A-4A (UBEC), 5.5V/1A (OPTO)

Standard configuration:SBEC 5.5V/4A

Shape and weight of ESC:

Dimensions(Length﹡Width﹡Height):67*32*23mm

Weight:99G (with BEC),94G (OPTO)

Positive and negative power wires:

wire size10 #   Material:Copper Silicone Wire  Color:+ Red - Black  Length:100mm

UVW wire: 

wire size:12 #  Material:Copper Silicone Wire   Color:U Black V Blue W Red

Length:80mm

Signal wire:

wire size:24#  Length:280mm   Connector specification:3pin DuPont terminal

Types suitable for T head     Rubber head Specification:￠5.0*20

Type:The power supply side can use ¢ 5.0 

Thrum heat shrinkable catheter specification:￠6.0*28       Color:Red, Black 

Heat sink specification:29*40                            Color: Silver

ESC heat shrinkable catheter tone specification:￠35*80      Color: Red

Manufacturers’ standard specification

Parameter settings of ESC:

Brake Setting:On/Off, the default is off

Setting for battery type:LiPo(lithium) or NiCd/NiMh,the default is LiPo

Low-voltage protection threshold setting:low/medium/high, the default is medium (3.0v/65%)

Motor timing setting(increase the efficiency and the start stability of the electronic governor): low/medium/ high, the default is medium (3.0v/65%)

Accelerated startup setting(for precision gearboxes and helicopters): (provide the rapid accelerated startup with linear throttle response), the default is soft

Helicopter mode (for helicopters), the default is off

Motor steering (clockwise/counterclockwise):forward steering/reverse steering,the default is forward steering

PWM operating frequency:8 KHz/ 16KHz, he default is 8 KHz

Low voltage protection modes (lower power or stop immediately):lower power/immediately stop, the default is lower power.

Standard configuration:

Power line length:100 (mm)    UVW line length: 80mm   no rubber head or T head     SBEC 5.5V/4A