| Model: | LS710 |
|---|---|
| Brand: | NANHUA |
| Origin: | Made In China |
| Category: | Consumer Electronics & Lighting / Lighting / Emergency Light & Indicator Light |
| Label: | aircraft , emergency light , led warning light |
| Price: |
-
|
| Min. Order: | - |
| Live Chat: | Last Online:01 Nov, 2017 |
Applications
Obstruction light for a wide variety of cranes used in Harbors, Metallurgies, Towers (Telecom,
GSM), Smokestacks, Buildings and any other potentially hazardous obstructions to air traffic with a steady burning red safety light.
Main functions and features
• Use Fresnel lens, high utilization of light, valid keeping light beam in the scope as required.
• Based on LED technology, low power consumption, and high efficiency.
• Lamp housing – Polycarbonate, with good anti-impact strength, thermal stability, high transmittance.
• Die casting aluminum enclosure with powder-coat paint finishes, providing corrosion resistance and durability.
• G3/4”pipe is available, ease of mount.
• EMC Compliance, No RF Radiation.
• Self-contained compartment, with stainless steel wire which is used to secure the unit against falling in operation, and ease of mount.
• Built-in photocell can switch ON/OFF the light at dawn and dusk (optional).
• Steady burning or flashing type (no need external controller).
• Extremely Reliable – Major Maintenance Cost Saving.
• External two M20X1.5 Waterproof gland( can be customized).
Specification
|
Standard |
Compliant to the ICAO(Aerodromes Annex 14) and FAA-L810 |
Vertical degree |
≥10° |
|
Light source |
LED |
Horizontal degree |
360° |
|
LED color |
Aviation red（Other color can be customized） |
Flashing rate |
Steady burning or flashing(flashing rate can be selected) |
|
Operating voltage |
AC110V~AC240V |
LED life |
≥100,000h |
|
Power consumption |
6W |
On/off level |
500Lux |
|
Intensity |
≥32.5cd |
|
|
|
|
|||
|
Operating temperature |
-40˚C ~ +70˚C |
IP Protection |
IP65 |
|
Relative humidity |
10% ~ 95% (no condensing） |
Weight |
1.0kg |
|
Material |
Base：Die casting aluminum Housing: PC |
||
Installation and operation
• Check whether the supply voltage does comply with the rated voltage of the lamp.
• Insert the power cable through the bottom of lamp holder, and connect them to the terminals in the base respectively.
• Follow connection diagram and set up work model. (remark: dial switch ON---1, figure---0)
• Tighten the screws between lamp housing and base.
• Screw the lamp on the mounting bracket, which should be fixed on a smooth surface with enough mechanical strength. Or you can select our mounting bracket: PJ024, PJ028 and PJ030 (installing diagram), special bracket can be customized.
• Switch on the power, and then the light works.
