Home > Products > Security & Protection > Access Control System

Channel

Two independent output channels

Power supply

DC6.0V, 1.5×4(AAA) batteries

Waveform

Bi-phase square-wave pulse

Output Voltage

Max:60V(1000 Ω Load)

Output Current

Max:60mA(1000 Ω Load)

Pulse intensity

0-60mA(1000 Ω Load), adjustable

Output intensity

0-60 levels, adjustable

Classification

BF type applied part, internal power equipment

Operating conditions

5°C to 40°C (41 °F to 104 °F )with a relative humidity of 30%-75%,atmospheric pressure from 700 to 1060 Hpa

Storage and Transport conditions

-10°C to 50°C (14 °F to 122 °F )with a relative humidity of 10%-90%,atmospheric pressure from 700 to 1060 Hpa

Dormancy current

Less than 80uA (At the power off mode)

Working current

Less than 170mA (At the 150HZ/300us condition)

Dimensions

129.7×76×35.1(mm)(L*W*H)

Weight

Weight 0.35 lbs(With battery)

Electrode Detection Function

The amplitude level will be reset to 0 mA when the amplitude level is 10 mA or greater and an open circuit at either channel is detected.

Output precision

All the output parameters allow ±20% error for the specification.

P.W. (pulse width)

50-300us

P.R. (Frequency)

0.5-150Hz

Burst Frequency

0.5-5Hz

Output characteristics

Constant Current(CC)

Normal

The pulse rate and pulse width output will be constant based on the setting value.

Pulse Width Modulation

The pulse width is automatically varied during a cycle time. The pulse width is decreased from it’s original setting to 70% during setting cycle time 5s, keep 1second and then increased from 70% to its original setting in duringnext setting cycle time 5s and keep 1second, and that cycle repeats. In this program, pulse rate (1 to 150Hz), pulse width (50 to 300us)

Pulse Rate Modulation

The pulse rate is automatically varied during a cycle time. The pulse rate is decreased from its original setting to 60% during setting cycle time 5s, keep1second and then increased from 60% to its original setting duringnext setting cycle time 5s and keep 1second, and that cycle repeats. In this program, pulse rate (1 to 150Hz), pulse width (50to 300us)

P.W. (pulse width)

50-300us

P.R. (Frequency)

1-150Hz

Contraction (on) time

0-30sec.

Relaxation (off) time

0-30sec.

Ramp up and Ramp down time

1-10sec.

Output characteristics

Constant Current(CC)