Product Description
Feature:
1). P8(120*3W) LED Grow light can replace triple to 5 times power of HID light, save about 80% energy..
2). P8(120*3W) with lens, which has a better focusing effect than that of traditional ones and increase the light intensity.
3). P8(120*3W) LED grow light with aviation plug type for power cord connection, more convenient in disassembling than traditional fixed type. User -friendly.
4). P8(120*3W) can simulate Sunrise and Sunset to feed the plant with certain light intensity, completely changes like the Sun. It' more scientific and reasonable for plants' growth.
5). P8(120*3W) grow light connected with screw for inside structure, not with glue, low voltage. The product process meet the Safety regulations, and pass CE, RoHS.
6). S ested ratio are (Red 8X10PCCS, Blue 8X5PCS, R:B=2:1) and (Red 8X9PCCS, Blue 8X6PCS, R:B=3:2).
7). Customized ratio and spectrum can be produced. Red 620-630nm & 640-660nm, Blue 450-460nm & 460-470nm is recommended to apply. Red stimulate germination, flowering and fruiting while blue promote leafing. Customized wavelength and ratio can be provided.
8). Built-in fans provide good heat-dissipation.
9). Built-in power supply, no need other device, directly plug AC85V~264V. No need for ballast,reflector.
10). Ideal device for different stages of plant growth, work well with indoor gardon, hydroponic plants and soil culture plants.
11). The lighting area and height will change to different plants and environment, parameters will change as well.
12). All applied material meet the requirements of environmental protection, no harmful substances as Mercury.
Manual for control panel:
1). Plug in, then turn on the switch, it need to warm up. When you see there are two line segments jumping, it means entering normal working.
2). There are 5 modes for the control panel: E1, C1, C2, C3, C0, among of which E1 imitate the Sunrise and Sunset automatically. C1, C2, C3 are manual diming modes. C1 is general channel, can adjust the brightness of both red and blue wavelength simultaneously. C2 can adjust red wavelength only while C3 can adjust blue wavelength only. C0 is "save" mode.
3). Displaying area shows the percent of the brightness, it's from 0-99%; But it shows the time where the light's working when under E1.
4). "+""-" key; it's 1% adjustment when single click while it's 10% adjustment when long pressing.
5). Press "MENU", it displays C1, then press "+" or "-" key to adjust the brightness of both red and blue simultaneously; You can also come to C2 & C3 to adjust the brightness of red or blue individually, then press "MENU" to go back to C1 and then to C0 to save the setting.
Under E1 mode, if press "MENU" key then it displays hour time ( From 00:00 to 23:00), you can set the hour time by press "+" or "-" key, after that press "MENU" to confirm, then the light will work from a new time.