Overview:
1. In conformity to IEEE 802.3 10 Base-T standard.
In conformity to IEEE 802.3u 100 Base-TX/FX standard.
2. Max. 2M buffer memory built in chip.
3. Back pressure flow control for full duplex IEEE802.3 X and half duplex.
4. Automatic identification of MDI/MDI-X cross line.
5. High-performance1.4Gbps memory bandwidth.
6. In conformity to safety code of FCC and 15 CLASS B and CE MARK.
Installation:
1. Interface
RJ-45 interface
The transmission media adopts CAT5 twisted-pair with typical length of 100 meter. It features the function of automatically identifying the through line and cross wire
Fiber interface
SC/ST fiber interface is of duplex mode type, including two interfaces, namely TX and RX. When the two sets of optical transceiver are interfaced or connected to switch with fiber interface, the fiber is in cross connection, namely "TX-RX", "RX-TX" (direct butting for single optical fiber).
2. Connection
The network device (work station, hub or switch) with RJ-45 interface is connected to RJ-45 jack of optical transceiver through twisted-pair. And the multi/single mode fiber is connected to SC/ST fiber interface of the optical transceiver. Then switch on. The corresponding LED is on for correct connection.
Technical parameters:
1. Standard Protocol: IEEE802.3 10 Base-T standard
IEEE 802.3u 100Base-TX/FX standard
2. Connector: OneUTPRJ-45connector, oneSC/STconnector
3. Operation mode: Full duplex mode or half duplex mode
4. Power supply parameter: Outside: 5V DC 1A
Built-in: 110-265V AC 48VDC
5. Environmental temperature: 0-60 degree
6. Relative humidity: 5%-90%
8. TP cable: Cat5 UTP cable
9. Transfer fiber:
Multi-mode: 50/125, 62.5/125 or 100/140μ M
Single mode: : 8.3/125, 8.7/125, 9/125 or 10/125μ M
10. Dimensions:
External power supply: 26mmx 70mm x 95mm
Internal power supply: 30mm x 110mm x 140mm
Cautions:
1. This product is suitable for indoor application.
2. Put on the dust cover of fiber interface when not used.
3. It is forbidden to stare at the TX fiber-transfer end with naked eyes.
4. Single optical fiber transceiver must be used in pair (See the attachment description in delivery).
| Explanation for LED indicator lamp |
| LED |
function |
status |
Describing |
| PWR |
Power LED |
ON |
Power is ON. |
| OFF |
Power is Fail. |
| FX |
Fiber port signal detect LED |
ON |
Laser is receiving. |
| OFF |
No laser input. |
| FX-LINK/ACT |
Fiber port link/action status LED |
ON |
Fiber link is ok. |
| Blink |
Data is been received or transmitted |
| OFF |
Fiber link is fail. |
| 1000M |
UTP port speed LED |
ON |
1000M speed |
| OFF |
100M speed |
TX-LINK/ACT |
UTP port link/action status LED |
ON |
Link is ok. |
| Blink |
Data is been received or transmitted |
| OFF |
Link is fail. |
| FDX/COL |
UTP port duplex LED |
ON |
Full duplex |
| OFF |
Half duplex |
