Home > Products > Electronics & Electricity > Motors

Flat motor 1020/0830/0827/0834/1034, mobile phone motor, 0827 motor, Huizhou Xinyu Electrical and Mechanical Services Limited large supply of flat vibration motor, mobile phone vibration motor following to introduce the flat vibration motor various advantages, for more understanding can log on to our website www.xinyumotor.com flat vibration motor for mobile phone of the miniature vibration motor is a DC motor with brush, motor shaft with an eccentric wheel, when the motor spins, eccentric circle particle in the rotation of the motor on the heart, which makes the motor at constant loss of equilibrium state, due to the inertia effect caused by vibration.

The main characteristics and application of

Permanent magnetic DC motor hollow

- small size, light weight ( cylinder )

Radial rotation / circumferential rotation ( flat ) - low noise, low power - Qiang Zhengan - has the advantages of simple structure and high reliability and short response time miniature vibratory motor are mainly used in mobile phone, toys, health care massager.

The flat vibration motor should pay attention to various situations

In 1, the motor at its nominal rated voltage when working with excellent comprehensive performance, s est that mobile phone circuit design of voltage as close as possible to the rated voltage design.

In 2, supplying power to motor control module should consider the output impedance is as small as possible, to prevent the load when the output voltage to drop substantially, impact vibration sense.

3 pole motor, inspection or testing locked rotor current, locked-rotor time should not be too long (less than 5 seconds as appropriate ), because stalling all input power is converted to heat ( P=I2R ), time is too long may cause the coil temperature rise and high deformation, impact performance..

4, with the mounting bracket of the motor in the design of positioning slot, and the mobile phone shell gap can not be too large, otherwise there may be additional vibration ( mechanical noise ), using the rubber sleeve can effectively avoid the mechanical noise, but attention should be paid to a positioning groove and a rubber sleeve should adopt interference fit, otherwise it will affect the motor the vibration output, decreased vibration sense.

5, transfer or avoid close to the strong magnetic area, or may make the motor magnetic steel sheet magnetic distortion and effects on performance.

In 6, when welding the welding temperature and the welding time attention, recommend the use of 320 ℃ 1-2 seconds, time and temperature is too high may damage the wire insulation.

7, from the box out motor monomer or in the welding process to avoid pulling on lead, also do not allow multiple large angle bending wire, or injury may lead.

Mobile phone flat vibration motor 1027 diameter 10MM thickness 2.7MM

Mobile phone vibration motor of flat 1030 diameter 10MM thickness 3.0MM

Mobile phone vibration motor of flat 1034 diameter 10MM thickness 3.4MM

Mobile phone vibration motor of flat 1020 diameter 10MM thickness 2.0MM

Mobile phone vibration motor of flat 0827 diameter 8MM thickness 2.7MM

Mobile phone vibration motor of flat 0830 diameter 8MM thickness 3.0MM

Mobile phone vibration motor of flat 0834 diameter 8MM thickness 3.4MM

Mobile phone vibration motor of flat 1227 diameter 12MM thickness 2.7MM

Mobile phone vibration motor of flat 1234 diameter 12MM thickness 3.4MM