Home > Products > Construction & Decoration > Building Steel & Structure

Concealed Sheet Forming Machine,
Bemo Sheet Forming Machine,
Concealed Roofing Forming Machine,
Joint Hidden Forming Machine:

ALLSTAR MACHINERY:Concealed Sheet Forming Machine,Bemo Sheet Forming Machine,Concealed Roofing Forming Machine

Main Parameter of the standing seam machine :

1) Steel Material: Q235,
2) thickness of material: 0.4-0.8mm
3) Feeding Width Max: 610mm
4) Capacity of Decoiler: 5000 kg
5) Inner Diameter of the Coiler: 500-600mm
6) Outer Diameter of the Coiler: 1800mm
7) Forming steps: 15 steps
8) Driving System: Chain Transmission
9) Power of main motor: 5.5kw,3phases, 415V, 50Hz
10) Reducer: Cycloid Pin
11) Power of Hydraulic cutting Machine: 3kw
12) Forming Speed Max: 15m/min
13) Dimension (L*W*H) and Layout:
Manual Decoiler: 1.1m*1.8m*1.2m
Main Machine: 7m*1.5m*1.3m
Runout Table: 4m*0.6m*0.8m

Main Configuration
1Manual Decoiler1Manual Expansion, 5T Capacity
2Main Forming Set1Chain Transmission, Motor, Green
3Cutter1Hydraulic, PLC Control
4Controller1PLC, Encoder, Touch Screen, Transducer,
5Hydraulic System1PLC control
6Runout TAble1simple
7Electric components1 setBreaker, contactor, limit switch, Relay
8Guard Cover1For the Chain, Yellow
9Seaming machine1To joint the panels for installation

Process and Features
Decoiler — Guiding —Roll Forming — Encoder —Hydraulic Cutter — run out table

process of the standing seam roll forming machine

1. This M/C adopts inner-expansion manual decoiler. The diameter can be adjusted through the adjusting bolt according to the coil’s inner diameter. The operation is quite easy. The decoiling speed is to the main machine’s forming speed.

2. The main frame is structured by welding entire T shape steel. The side stands are welded on the frame, and to clear the stress by vibration in order to maintain the rigidity and stability of the machine.

3. The forming rollers are made of GCr15 bearing steel through a series of heat treatment such as forging, distressing anneal, high frequency hardening(the degreed is 8-10mm), backfiring, phosphorization etc. The surface of the rollers can reach the rigidity of HRC58-62. All the forming rollers are process on CNC lathe, by which the accuracy can be granteed.

4. The main shaft is made of 40Cr advanced alloy steel after a series of heat treatment such as high frequency hardening, quenching and tempering etc and processed on lathe, burnishing the surface, wire cutting the channel to make it high accuracy and large capacity.

5. Cut to length is the last process of this machine line. It cuts accurately to any length you set on the PLC. The cutter consists of Hydraulic diver, profiled blade and cutter frame. The blade is made from Cr12 cold punching steel after strict process. It adopts 45 degree staggering cutting. This costs no waste and can hold the cutting profile a good shape. And this cutting is of high accuracy