Home > Products > Industrial Supplies > Tools > Abrasives

HOW TO USE MARBLE CRYSTALIZER 

1,  sweep the floor to remove loose floor debris.

2,  Make sure that the floor is free from wax and dirt by stripping it with a wax stripper solution and black stripping pad.

3,  Rinse or damp mop the floor with clean water thoroughkly ,making sure there is no residueof stripper solution left on the floor  .

4,  On a two (2) to three (3) square meter area,spread 2 to 4 tablespoonfuls of powder and 150 to 250 ml of water directly on the marble floor .

5,  Place a low speed (175to 300rpm) floor polisher with red polishing pad on top of the marble crystalizer powder and buff the floor . 

6,  Do not allow the solution to dry .keep it wet  by adding 100 to 150ml water regularly.

7,  Using a floor squeegee ,inspect the area being crystallized after 4 to 5 minutes and check if the marble has reacted already.

8,  If the marble exhibits a wet look gloss already ,transfer the used solution on adjacent untreated area by using the floor squeegee.

9,  Rinse the finished area well with mop and clean water .

10,To maximize the product ,re-use the solution from step 8 for a few more minutes on the adjacent untreated area before picking it up with a wet vaccum or mop .place new marble crystalizer and water on this area and repeat steps 4to 10.

11,After the entire floor has been crystallied ,damp mop or scrub the floor   (with a clean red pad)and clean water .let dry .

12,Remove the remaining marble crystalizer powder residue from the floor by dry buffing the floor .this is done by placing a thick ,round circular cloth under the polisher and dry buff ing the entire area.
Xingyi Polishing Machine Co.,Ltd.     
F: 0086-595-36792977
M: 0086-15960788328
skype:xingyistone211