Product Description
Manual
2.4GHZ 3W
A, the machine uses voltage
Transmitter ( TX )
Power Input Voltage: AC :100V ~ 240V 50 / 60Hz
Output Voltage: DC +12V 2A
Receiver ( RX )
Power Input Voltage: AC :100V ~ 240V 50 / 60Hz
Output Voltage: DC +12V 1A
B, properties
1. This machine select an general international standard frequency :2.4GHz , anti-jamming performance .
2. Circuit (GaAs) gallium arsenide power amplifier tubes, efficient, to receive the image clear and stable, longer transmission distance, there is no obstacle in the conditions of use of this system, wireless transmission distance 1500M-2KM , coupled with 24dB high gain directional parabolic antenna, distance to 10KM above.( . To meet the needs of remote users, you can choose to buy my company's high-gain parabolic antenna, please contact seller consultation)
3. For select more channel, the mutual interference between difficult channels
4. With extended frequency functions, multiple frequencies can be extended up to 8 scalable frequency
C, performance indicators
1. Working frequency: 2414MHZ-2468MHZ (general standard )
2. Extended frequency ( 2370MHZ-2510MHZ )
3. general use 4 Channel , can be expanded to 8 channel.
4. Can transmit two-channel stereo audio signals and one video signals
5. Video signal system : PAL / NTSC
6. Audio input impedance :1KΩ.
Transmitter Video Input impedance: 75Ω
Video output impedance receiver:75Ω
D, installation
Note:This system consists of transmitter and receiver , the iquipment write the "Transmitter" for the transmitter, referred to: TX;and the "Receiver" for the receiver. referred to: RX.
1. Transmitter rear bezel purposes:
VIDEO ( video input )
AUDIO R ( right channel audio input )
AUDIO L ( left channel audio input )
2. Transmitter front bezel purposes:
input Voltage jack: DC IN 12V
power light :LED
frequency : CH SELECT
Antenna: ANT
3. Receiver rear bezel purposes:
VIDEO ( video output )
R AUDIO ( right channe output )
L AUDIO ( left channel output )
4. Receiver front indicators
input Voltage jack: DC IN 12V
power light :LED
frequency : CH SELECT
Antenna: ANT
5. Select the device operating frequency.( Note: The transmitter and receiver must be set to the same frequency, otherwise not receive the signal! )
6.The receiver audio and video input connect with TV or Monitor audio and video cable output .
7. Installation of equipment antenna.
8. Plug in the power matching, power indicator light.
Transmitter and receiver installed, observe the reception by adjusting the angle of transmitter and receiver antennas, so that voice and image to achieve the best effection.
9. Device provides four options for the frequency setting switch, channel switch down to disconnect a valid channel number:
Paking List
1. Transmitter and receiver
2. DC power: 2 adapter ( TX transmitters; RX Receiver )
3. 2.4G machine dedicated :2 antenna
4. Stereo AV Video: 2 cable
5. manual
Product Image
Img 1
Img 2
Send Inquiry to this Member
Related Products of this Company
This member assumes full responsibility for the content of this listing. DIYTrade accepts no responsibility whatsoever in respect of such content.
To report fraudulent or illegal content, please
click here.
China Suppliers Quick Searching:
,