Home > Products > Electronics & Electricity > Switch > Other Switches

Function and Use

The product adopt imports high performance timing chip,which auto-turn on and auto-off the power of electrical equipment,according to set parameters by user,Widely used in various electrical equipment of the timing auto-control,for example,street light neon-light,advertising light,rice cooker aerator irrigation system,pre-heating,pre-coding devices,ect.

Performance Indicators

Rated voltage:220V/50HZ

For voltage range:180V~240V

Rated current resistance load:25A

              Sensiblity load:16A

Power consumption:<4VA

Time control range:1min~168hour

Timing deviation:<±2see/day

Temperature:-45°C~60°C

Relative humidity:<95%

Shape size:115*75*52mm

Wiring type:lock type connecting

Time type:24 hours

Control cycle:day or week

Display symbols to explain

Rain sensor to use light control

1, Do not plug in light control rain control probe or probes, its use with the timer switch to use the same.

2, Light control to use: plug in light control sensor, if light, switch off for about a minute or so; the absence of light, about five minutes identification restitution switched on and off the general illumination for the 25LX ± 5LX.

3. Rain control to use: plug in the rain control probes, such as rain sensor probe, switch off immediately, no rain for about five minutes after the identification restitution connected, power resistor 50KΩ, power resistor 1MΩ.

4. Light control and rain control simultaneously: while pl ed in light control, rain sensor control, or in a light rain of any state, the timer switch off; such as light and rain are not, the timer switch according to the original program is working.

5, Above  rain, light control two power down protection functions required to adjust the time-control switch in the "automatic" or "open" position can only work.

Fault

If the switch is opened one day the time did not open, or opened after the time to not shut off, it may be because the time set for the "week" did not transfer right, follow the "time setting" in the inspection method described in or re-tune.

 If you confirm "open" and "off" time adjustment was entirely correct, but should not open the switch in time to open up, or should not be closed when the
Is turned off, it is probably because the extra time does not eliminate the groups switch, please refer to "time settings" to eliminate the method described in (note: switch
Between the ":" only said to eliminate, do not think "00:00" for elimination)

If these two all right, but the switch still does not work normally, there may be "automatic / manual" key is artificially action, check the "open, automatic, off" signs "," be transferred to the current time in which the state, then transferred back to the automatic position.

Several methods such as using the above faults can not be excluded, please fell free contact to our comany.

Notes

1. If on the display becomes weak, replace the battery; if the set is erased, need to re-set

2.Do not repair, disassemble or modify the product

3. Do not touch the terminals after the power part

4. The switching in the absence of moisture, corrosive gases and high metal content.

5. Do not dye it sticky oil or water

6. This product warranty is one year

Product performance standards

GB14048.5
GB 14536.8-1996
Q/ZL-2004-01