ELM327 USB OBDII Interface

Introduction:

ELM327 USB is the latest PC-based scan tool. It supports all OBD-II protocols and is dispatched with a number of compatible programs. The processor is an ELM327 USB. The output protocol (connection to laptop) is USB

OBD-II Protocols:

* ISO15765-4 (CAN)

* ISO14230-4 (KWP2000)

* ISO9141-2

* J1850 VPW

* J1850 PWM

* Output protocol: RS232

* Baud rate: 9600 or 38400

* Indicator LEDs: OBD Tx/Rx, RS232 Tx/Rx, Power

* Operating voltage: 12V, internal protection from short circuits/overvoltages

* Nominal idle current: 45 mA

The program is very user-friendly, and easy to learn. It is also very easy to install:

* simply extract the files into a folder on your computers hard drive, and youre ready to go. To uninstall the program, simply delete the entire contents of the folder where the program resides.

* The software supports two platforms - DOS and Windows.

The program lets you perform the following operations:

* Read diagnostic trouble codes, both generic and manufacturer-specific, and display their meaning (over 3000 generic code definitions in the database)

* Clear trouble codes and turn off the MIL ("Check Engine" light)

Display current sensor data, including:

* Engine RPM

* Calculated Load Value

* Coolant Temperature

* Fuel System Status

* Vehicle Speed

* Short Term Fuel Trim

* Long Term Fuel Trim

* Intake Manifold Pressure

* Timing Advance

* Intake Air Temperature

* Air Flow Rate

* Absolute Throttle Position

* Oxygen sensor voltages/associated short term fuel trims

* Fuel System status

* Fuel Pressure

* Many others...