|Origin:||Made In China|
|Category:||Industrial Supplies / Electrical & Electronic Product Equipment|
|Label:||power plug test , continuity polarity , insulation test|
|Min. Order:||1 pc|
|Post Time:||30 May, 2010|
|Last Modified:||05 May, 2011|
|This Co. have total 19 Related Items||12345678910Next|
This tester is a integrated tester for plug. It is used to test the continuity, insulation, high-volt, leakage current of power plug. It meets the requirements of many international standards such as BIS, UL, CSA, VDE, BSI, DIN, CCC, IEC, etc. It is a automatic testing machine make your operation more convenient and simple.
* All of the test subjects will be done automatically.
* The inner/outer high-volt value and persistence time can be adjusted separately.
* Test speed very quick, all test subjects will be achieved only in less than 2 seconds.
* The PLC control system is come from Mitsubishi, Made In Japan.
* The relay is come from Schneider, Made In French.
* If the sample is incompetent, there is a alarm by noise and alarm light.
* If the sample is incompetent, this machine will stop at once and show you which subject is incompetent. After pushing the emergency button, it will restart to a new test. And a switch with key can be made to order to replace the high-volt starting button, it is very useful, because when a alarm happen, the operators can not restart this machine, only when the managers have checked over and restart it by key the machine will be working again.
* When test over, the sample will be pushed out automatically, and a T or other characters will be marked on it (only English characters).
* used for double-headed power plug. This makes your test more quickly.
Polarity test: Test E, L, N wires in sequence
Insulation test high-volt: DC 500V +- 10%
Insulation resistance: 2, 7, 20, 50, 100MΩ (can be made to order)
Inner high-volt: 0~5KV +-5% (adjustable)
Outer high-volt: 0~5KV +-5% (adjustable)
Leakage current: 0.5, 1, 3, 5, 10mA (can be made to order)
Rated power: 500VA
Cylinder power: compressed air with 0.4 to 0.6Mpa
Power source: AC 220V +- 10%, 50Hz
1. Inner high-volt is applied between L, N, E wires, and the outer high-volt is applied between L, N, E wires and jacket.
2. Both 3-wire and 2-wire power plug can be tested by this machine.