Home > Products > Electronics & Electricity > Electric Control System

The GCU-10 Generator Control Unit is an universal economical programmable genset controller. Equipped with high illuminating LED with universal graphical interface helps to notify the operator the generator status. Optional relay module GCU-10R (12V/24V) and GCU-11R (12V/24V) helps to simplify the wiring and connection process.

Features

• Microprocessor Based Design
• Universal LED Graphic Interface, Displays Generator Status and Failures
• Modular Design, Quick Installation
• Programmable Engine & Generator Controls Adapts Easily To Any Type Generator Set.
• Waterproof Front Panel With UV Protection
• Provide IDLE control For Elec. Governors
• Five Adjustable Time Delay Potentiometers
• Five DIP Switches For Specification Setting

Specifications

DC Supply	9.0 to 36 VDC
Alternator Input Range	Voltage 5~300 VDC Frequency 50~60 Hz
Fuel Solenoid Signal Output	5Amp @ 12/24 VDC
Start Signal Output	5Amp @ 12/24 VDC
Warm up Signal Output	5Amp @ 12/24 VDC
Accessory " ON " Output	5Amp @ 12/24 VDC
Idle Control Conductor Capacity	5Amp @ 12/24 VDC
Power Consumption	Under 3 VA on Auto
Adjustable Timers	Engine Pre-Heat : 2~30 sec. Starter Cranking Time : 1~15 sec. Energize to STOP : 1~15 sec. Engine Idle (Governor) : 0~300 sec. Engine Cool-down : 0~300 sec.
Protection & Alarm Status Indicators	Start Failure High Water Temperature Low Oil Pressure Overspeed Underspeed Emergency Stop Extra Prog. Input Low Battery Voltage
Environment	Operation Temperature : -20~70 °C Relative Humidity : Maximum 90%
Panel Installation Cut-Out	66.0 ± 0.5 mm x 66.0 ± 0.5 mm
Weight	100 gram