Home > Products > Electronics & Electricity > Electronic Components > Other Electronic Components

The molding is designed by special industrial molding design office and is unique, vogue,pioneering with third-dimension and streamlined appearance and is close to humanization.
The aluminum alloy material is considerately selected: Japanese trademark is ADC12, and USA trademark is A360.
The surface is done with shot blast cleaning,deactivation and polishing yellow chromate treatment, salt mist-proof test is done three times in consecutive within eight hours, and no rust occurred.
The surface is treated with anticorrosive paint baking and the thickness of baked paint should be no more than twenty five a deviation of five um, and static coating should be no more than fifty a deviation of five um,make nine grids within an area of thirty two mm*thirty two mm, use adhesive tape to test adhesive force, stick ten times in consecutive without any drop out.
The groove of the product is embedded with metal gauze screen so as to prevent radiated disturbance and has a good earthing,screening and anti-leakage performance.
He product is sealed with silicon rubber strip and can resist temperature as high as two hundred degree centigrade and as low as eighty degree centigrade below zero and will have no distortion.
Sealing requirement is no leakage within two minutes under point zero senve MPa air pressure