Home > Products > Sports & Recreation > Entertainment > Musical Instrument

Output Power:100W(RMS),

Woofer:8(inch) 4(ohm) Full - frequency speaker,

370(W) * 300(H) * 240(D) mm, Power Consumption: 105W.

1/4" jack for instrument input and MIC jack for instrument input.  

Signal source selector switch - line (only via jackplug) for instruments ( pikcup) and other line level sources, mic ( only via XLR - connector) for microphones.  

Use the Gain knob to set the signal level for the instrument input of INP.1.

1/4" jackforinstrument input.  

Input sensitivity switch, attenuator.  

Use the gain knob to set the signal level for the instrument input of INP.2.  Overload indicator.  

Tone colour filer activation switch.  

Bass, Middle and Treble frequency frequency level control.  

Effect level control(Reverb) , ON / OFF Status indicator, Master level control, Turns amplifier ON & OFF.  Operate the amplifier only at the voltage indicated on the rear pandl.

This output enables you to connect stereo headphones and mutes the loudspeaker.  

the line out suppliers a pre-amp signal taken aftertone-control , effects and master for forwarding to other appliances.  

Return as part of the effect loop operates as signal input from an external effect device (from output of the effect device).  

The effect can be swithced on or off via footswitch.  

Return on its own can also be used as quasl ausillary signal input(-10 dbV).  

Send is an output to connect to an external effect device and in conjunction with return (input) froms a loop here designed as external effect loop.  

The effect can be swtiched on or off via footswitch,  Preamp-output with symmetrical signal, after tonecontrol, pre master, without effects.