Home > Products > Construction & Decoration > Curtain Wall

Product features

F104 laminating adhesive is a solvent-free, excluding JiaQuan, excluding stupid a two-component epoxy composite adhesive, has excellent mechanical performance and the construction time is long, easy to hang glue, water resistance, alkali, acid, mechanical performance effect is excellent. The main agent and curing agent (A, B) weight ratio of 2:1

Application field

External aluminum honeycomb panel, decorative board, metal plate clean partition, ecological doors, bathroom toilet partition of adhesive, such as: color steel plate, aluminum, aluminum honeycomb panel (paper), PU, rock wool, plasterboard, baume plate, such as composite adhesive, for metal, wood has excellent adhesive performance.

L technical parameters (the following parameters of 25 degrees Celsius temperature test)

The main agent curing agent (B) (A)

Status: fluid viscous fluid

Density: 1.50 + / - 0.05 g/cm3 0.05 + / - 0.05 g/cm3

Color: grey light yellow

Viscosity: 6500 + 1500 mpa s. 7000 + 1500 mpa, s

Mixing ratio: 2 1

Mixture density: 1.47 + / - 0.05 g/cm3

Sizing time: 90-120 minutes (after mixing) can be adjusted according to the production requirements

After mixing state: fluid

Glue dosage: 250-450 g/cm2

The initial moisture time: 6 -- 9 hours

Fully viscous force time: 5-7 days

No exothermic peak: 20 days

Tg: 60-62 degrees Celsius

Steel shear strength of steel, more than 20 mpa

Environmental performance: in accordance with GB18583

Apply after curing temperature: - 40 - + 100 degrees Celsius

Matters needing attention

1. The construction

2. The main agent and curing agent gets sticky under 15 degrees Celsius, and must be heat treated (heating temperature in 40 to 60 degrees Celsius);

3. F104 can be used at low temperature, 10 degrees Celsius under low temperature curing speed is slow, such as to accelerate the curing speed can heat curing); Also can be used at high temperature, 65 degrees Celsius cure time 45 minutes, curing time of up to 80 degrees Celsius for 20-25 minutes;

4. The adhesive substrate must be oil removal, dry, dust-free, clean processing, it is recommended to use must be cleaned up when the bonding strength increased significantly;

5. Must store in dry indoor environment, recommended temperature (16-35 degrees Celsius), avoid direct sunlight, high temperature storage, below 15 degrees Celsius, damp environment;

6. Warranty: intact packaging for 12 months

7. Packing: the main agent (A) 25 kg plastic drum, curing agent (B) 25 kg plastic drum, can also according to customer's requirement in cans.