Home > Products > Consumer Electronics & Lighting > Lighting > Outdoor Lighting

PRODUCT:  2015 new waterproof led solar motion sensor light

*Brief introduce

• 1. This product is a soft of energy-saving solar product with portable installation
• 2. It applied widely for illumination in courtyard, street, garden, plaza, etc.
• 3. Easy installation: fixed installation and separated installation. No need any line arrangement and other complicated install process.
• 4. Use solar-charging system, light controller and human induction control. So it would turn off automatically in daytime, turn on when people walking nearby. No need any manual control for the button of light
• 5. Adopt Ultra-thin design, and base on side lighting principle so that the light would be gentle and not dazzling 

Product Description

* Solar motion light Specification:

  Outdoor High Lumen Integrated Motion Sensor Led Street Garden Solar Light

*Product Performance

• 1. In daytime, the system is charging and light would be off: while at night, the light of the system would tum on automatically with human infrared sensing
• 2. It would be full-charged with 7-8 hours in a good sunny day. With 15 seconds stand by time in lighting. It means the light would turn off automatically 15 seconds later after people leaves, but stay lighting state when people is nearby
• 3. Operation mode: ON/OFF lighting control and human induction control.

*Functions:

1. After receipt of the product, firstly insert the needle into the small hole marked ON/OFF, then LED light would flash 3 times which indicates system is on.

2. After the start of light, fix it in support with screw to make sure the tightness of light and support. If easy exchange is required, the screw behind the support should not be fixed.

3. Fix the support against the wall

4. Make sure for the enough sunlight. When the panel absorbs the solar energy, light below <5> hole would be on to indicate it start charging

5. CDS is the function to detect whether it is in daytime or at night. When in daytime, system light would not turn on since CDS automatically detect the daytime. While at night when CDS detect the weakness of light, system light would be turn on.

*Installation:

Due to the solar energy product, we sincerely advice to pick up the place with better sunlight and should face to South.

For more time this system enjoy the sunlight, more energy would be kept and can light more time at night.

Installation height should be around 3 meters according to our advice.

*Additional remark

1. Due to solar energy product, the time of light should be closely effected by the situation of local weather, need your understanding for such point.

2. Lithium battery is included in the system, therefore, if need to exchange for battery, please do not put in the same place. And should never put into fire because there might be potential explosion danger

3. The case of this product is made of aluminum and plastic, therefore, take care to avoid any crash and fall-down to escape from any damage of the product.

Power switch next to the hole in the sensor head, the needle is inserted into the hole in the kit by clicking KED light flashes three times to start after starting, as long as the human senses can dull night light LED

1. The light-emitting surface

2. CDS light control

3. Sensor

4. ON/OFF

5. Charge indicator

Contact Coco