Home > Products > Industrial Supplies > Machine Hardware > Other Machine Hardware

Brief Introduction

Surface type concrete vibrator is an essential tool for concrete vibrator, which is widely used in modern construction engineering dense concrete vibrators work. It can be not only used for the concrete foundation level and various parts of the surface of the concrete structure of the work of the tap,but also be installed in a variety of vibration shaker and other equipment and used as a source of vibration.

Structure Features of three phase industrial electric Motor

1. It's made by adding two eccentric mass to each of the two end of one-phase, three-phase asynchronous motor armature.

2. It's completely dosed and string, conveninet to be disassembled and repaired. Power wires are made of four-core rubber cable.

3. The shell of the machine is made from aluminum alloy. It has light weight and high efficiency. Two covere are fined by three screws.

Method and Caution of three phase industrial electric Motor  

1. Keep rice insulation of motor. If it hasn't been used for a long time or should be transported, please check the phase coil insulation and ground insulation. The resistance can't be less than 0.5Ω at the same time check the power.

2. When installed, the location of the base plate screw should be properly and avoid skew bolt, preventing the body from receiving the abnormal stress and affecting the life. The end of bolt and nut must be tightened, and to make the tightening force to maintain balance.

3. It can't be used on the dry ground for a long time. In order to protect components from being rumed by over vibrating. Security and operation specification should be strictly observed. The motor should be eqiuped with leakage switch. Please check the resistance to the ground in time.