Home > Products > Security & Protection > Alarm

One. Introduction
Security camera display can show micro-SLR camera digital cameras and other digital products, from the built-in alarm host, alarm sensor, display frame and other components. Mounted display or a display case above, the police probe in the exhibition by 3m adhesive items above, the customer can remove aspects of the exhibition items from the shelf above, freedom of exhibitions feature articles appearance and operation of the trial, if the customer want to exhibit away, the alarm will sound a continuous alarm immediately, the alarm will continue to sound management staff to take up the remote control to do a reset
Two. Product performance parameters
1. Product dimensions: length 75mm width 50mm height: 140mm
2. Battery type: 3.7v
3. Charging voltage: DC 5v
4. Standby time: six months
5. Alarm sound: 105 db
6. Fortification method: infrared remote control

Three. Product Features
1 alarm function: If the cable is cut or the probe and the probe exhibit separation, the system will call the police.
2 long standby: one charge system can rely on internal battery standby than one year.
3 Multi-Tamper Alarm: Provides tamper machine, such as multiple brackets tamper tamper protection.
4 Charging Function: The system can provide a charging voltage of 5V, the realization of digital products charge.
5 Remote Switch: Infrared remote control function of each port automatically detects the alarm reset function probe
Four. Usage:
1 adhesive protective film will tear up the bottom of the alarm, stick to the clean, flat desktop
2 holes aligned digital camera sensor spring wire bracket to find the right position with the screw holes on the flat fixed alarms and cameras with fixed soon after the alarm will ring alarm proved to enter the work state
3 Plug the power cord into the jack on the left side of the alarm this time the red light has been proven alarm automatically turns off after charging full blue lights for the alarm did not enter the working state or alarm failure
5 default password is 345, if the alarm please use the remote control towards continuous alarm button is pressed 345 lift alarm sounds
V. Use the remote control
1 Change Password: alarm from the right side of the phone line jack unplug the sensor spring line this time the alarm will alert the blue indicator light flashes
2 Press password disarm the alarm then press the remote control button for five seconds to set a password to hear the old password correctly after the alarm sounds for two seconds and then enter a new long-rang-digit password at this time the alarm rang two seconds long, then enter the new password twice after entering the correct password again new alarm rang three new password to make sound
3 Note: The password is entered three digits must be the same new password twice at intervals of not more than 15 seconds input
More than 15 seconds the alarm will beep again expressed the need to change the password timeout settings button on the remote control to modify
4 Forget Password: the packed alarm removed from the desktop with paper clip into the back of the alarm by clicking the blue hole this time the alarm indicator flashes three times to restore the factory default state status code is 345
VI. Precautions
1. The removal of any component of the product is prohibited to affect product functionality and service life
2. Built-in battery standby for the six months of normal, please charge when the battery is low
3. In order to ensure the detection of all the normal host communication ports required communication lines connecting each probe carried out properly before use
4. To prolong battery life, the proposed development machine normal charging time is not more than eight hours, not long-term access to the charger
5 Note viscose instability, do not continue to use the product for your safety, please contact your dealer