Home > Products > Industrial Supplies > Packaging Related Machine

Adjustment kit product control contact lever unit

Use: This kit was created as an accessory for the pantograph format changeover positioners.It allows
adjusting the height of the control contact lever unit in order to detect the product flow.
State of supply
- VERSION KT E
nominal torque transmissible 4.5 Nm.
Kit complete with 1 drive jack with RAL2004 orange reduction gearbox in reinforced polyamide, 1 phosphated
steel worm screw connected to the RAL9005 black reinforced polyamide knob with torque limiter
secured with M6x25 UNI5739 hex head screw and M6 screw washer, 1 RAL1006 yellow polyamide screw
cap, 1 brake with RAL9005 black reinforced polyamide tightening wing nut (RAL2004 orange wing
nut cap), 1 gearwheel in neutral polyamide; 1 idler jack with reduction gear box in RAL2004 orange reinforced
polyamide , 1 gearwheel in neutral polyamide;
2 racks in galvanised steel, 2 bracketing plates in AISI 304 stainless steel, hexagonal transmission
shaft 16 in galvanised steel, M20 tracer bar in galvanised steel, control contact levers in RAL9005 black
reinforced polyamide , 8 UNI5739 M6x55 hex head screws, 8 UNI7474 M6 self-locking nuts, 16 M6 screw
washers, 2 UNI5739 M8x20 hex head screws, 2 M8 screw washers.
 

Characteristics: he synchronised movement of the two jacks occurs by means of the hexagonal transmission shaft. The drive jack is equipped with a brake that eliminates loss of position caused by external factors (e.g. vibrations).
Warning: in order to protect the internal transmission devices, if you use the knob for movement, the brake will not fully lock the position.
Maintenance: not required.
Standard pack: 1 piece.
C TECHNICAL DATA:
Kit's vertical travel: 470 mm
Rack's travel per turn: 1 knob turn = 8 mm of rack travel.
Reduction ratio i=16 (16 knob turns -worm screware equivalent to 1 turn of the worm gear with hexagonal seat).
Operation: manual, if motor-driven max. 70 rpm;
max time: 1 min;
STEP BY STEP (NO continuous operation).
On/off ratio=1/9.