Home > Products > Electronics & Electricity > Electronic Instrument > Balance & Scale Apparatus

258-24 Starrett DHG24.258 Digi-Check Height Gage .100"-24.100" Range

258-24

DHG24.258

.100"-24.100" / 2-602MM RANGE

GRADUATION SCALES IN INCHES

.001' DIGITAL READOUT

.0001" MICROMETER HEAD

+/-.0002" GAGE ACCURACY

EDP NO. 93357

READABILITY FEATURES

SATIN CHROME SCALES MOUNTED BESIDE THE GAGE BLOCK COLUMN FOR QUICK REFERENCE TO THE NEAREST 1" OR 25MM READING

DIGITAL READOUT READS IN .001" OR .01MM AND HAS A RANGE OF 1" OR 25MM

READS DIRECTLY FROM THE MICROMETER HEAD TO .0001" OR .002MM. THE MICROMETER HEAD HAS BLACK FIGURES ON THE SATIN CHROME THIMBLE. THE GRADUATIONS ARE STAGGERED FOR EASY COUNTING

BOTH THE MICROMETER HEAD AND DIGITAL READOUT ARE MOUNTED ON TOP OF THE GAGE DIRECTLY IN LINE WITH THE OPERATORS VISION.

THE MICROMETER HEAD HAS A SPEEDER KNOB FOR RAPID POSITIONING

BOTH OVER AND UNDER HEIGHTS CAN BE CHECKED DIRECTLY FROM THE GAGE BLOCKS IN A SINGLE SETTING BECAUSE REFERENCE SURFACES  ARE PROVIDED ON THE TOP AND BOTTOM OF EACH BLOCK, ADJACENT BLOCKS ARE IN THE EXACT SAME PLANE. THIS ELIMINATES THE NEED TO ADD OR SUBTRACT BLOCK THICKNESS.

READINGS CAN ALSO BE TAKEN FROM EITHER LEFT, CENTER, OR RIGHT OF THE GAGE BLOCK COLUMN.

PARTS CAN BE CHECKED FROM .100" OR 2MM IN HEIGHT.

THE GAGE BLOCK COLUMN DESIGN PERMITS WRINGING A 1" BLOCK BETWEEN TWO BLOCKS IN THE COLUMN. THIS IS CONVENIENT FOR SETTING AND CHECKING OTHER GAGES SUCH AS INSIDE MICROMETERS, AND END MEASURING RODS, DIAL BORE GAGES, ETC.

GAGE IS HOUSED IN A HEAVILY FLANGED FRAME FOR STABILITY AND THE BASE HAS THREE POINT HARDENED, GROUND, AND LAPPED BEARING PADS, MAKING IT VIRTUALLY TIP PROOF GAGE BLOCKS ARE ASSEMBLED IN A FREE STANDING SYSTEM THAT ALLOWS THE BLOCKS TO CONFORM TO TEMPERATURE VARIATIONS INDEPENDENTLY OF THE FRAME, THERE BY READING THE SAME AS THE WORKPIECE.