Home > Products > Consumer Electronics & Lighting > Lighting > Bulb & Lamp

Specifications

1.best price 
2.ul,cul,dlc,ce,rohs listed 
3.5 years warranty 
 

T8 LED TUBE  HC-T8C-2FT-8W-ID 

Specifications

High Brightness  587mm 8W T8 LED Tube 

1.Power Factor>0.92

2.CE&RoHS Approval

Benifits of LED Tube t8:

1.Solid-state, high shock/vibration resistant.

2.No RF interference, no buzzing noise.

3.No fluorescent flickering.

4.Mercury and Plumbum free,Environment-friendly facility.

6.Maintenance free, easy installation.

7.Long lifespan up to 50,000h.

8.Low power consumption, high intensity.

9.Isolated light source which is more reliable and convenience.

10. SMD2835 technical and advanced heat-sink frame design reduce chip attenuation.

OUR LIGHTING ADVANTAGES:

1. Patent products, with UL,DLC,CE, RoHs certificates. LM-79&LM-80 test report,IES files ( Photometric Lux )

2.Rotatable end cap and standard cap available;

3.Patented heat sink and optical diffuser;

4.Wide voltage and constant current design,used in most of countries;

5.High lumens SMD3528 from Original  Bridgelux ;

6.G13 bi-pin,single pin base,R17D optional ;

7. L&N in the same end or in two end optional

Quality Control of T8 LED Tube:
100% of the lamps will be tested and keep lighting for 24 hours to test its quality reliability , and we will also test its temperature after 24 hours’ lighting.
Then after it is cool we again test 100% of the lamps to see if it still work well . Each lamp should pass all these QC procedures before shipping to customer.

Installations of LED Tube:

Attention:1.If the conventional tube is with electronic ballast,please take off the ballast and make replacement with LED tube according to the circuit diagram.

                     2.If the conventional tube is with inductive ballast,please take off the ballast and starter,then make replacement with LED tube.  

WARNING: LED tubes do not require a starter or ballast mechanism to operate. This actually makes them electrically more straight forward with fewer components to go wrong. However, when replacing an existing fluorescent tube with an led tube the existing fitting will need to be modified to bypass the old ballast and starter mechanism. This is not a simple process and unless you are confident in your electrical abilities, we recommend this is carried out by a qualified electrician.

Packing for LED Tube: