Home > Products > Industrial Supplies > Machinery > Pumps Vacuum Equipment

Our Hot water submersible pump motor power range from 1.5KW to 410KW, big power submersible electric pumps are our main products. If you are interested in our goods,Please tell us your flow and head requests, your well diameter, we will help you select a suitable model and give you a good quotation.

Looking forward to your inquiry.

Operation parameters

 1. Flow range:10-500 m3/h

 2. Lift range:10-600m

 3. Applicable well Borehole diameter:φ175-φ400mm

 4.Diameter scope:φ32—φ203mm;   

 5.Temperature range: -15—100°C.

Hot Water Pump Product overview

Hot water submersible pumps are widely used in

1.agriculture irrigation, sprinkler    irrigation, well water lifting

2.water supply, drain system of industrial and civil building

3.the hill, mountain areas' water diversion, drainage of low-lying area

4.water supply, drainage of industrial and mining enterprises in urban and rural area

5.all the other water facilities

This pump is widely used for the irrigation for agricultural land, the water supply and sewage for industrial and mining enterprises, and the water utilization for the people and animals in altiplano and mountain area, the electric supply is 380V 50HZ 3phase AC.

Hot Water Pums Material

Impeller:Cast iron HT200,or stainless steel

Pump bowl:Cast iron HT200,or stainless steel,such as ss304 ss3016

Pump shaft :Cold-drawn steel with chrome plating,or stainless steel ss304 ss316

Motor Seal:Rubber O-ring seal,mechanical seal

Motor regulating sleeve:rubber

Hot Water Pumps Characteristics

Motors and pumps assembled into one.

Simple structure.

Easy installation and removal, small area.

Simple using and maintenance.

Safe and reliable operation, no pollution to water, etc.

 Use conditions of Hot Water Pump

1. QJ Submersible pumps use conditions:

(1)380 V bias voltage does not exceed +/-10% and 50 HZ frequency, and the deviation is not more than + -1% of the three-phase power supply.

(2) Electrical cavity must be filled with water during operation.

(3)The first-class pump impeller should at least go into a dynamic water level 2 m below surface. Static pump unit immersed under water shall not be greater than 70 m in depth.

(4)The normal water temperature should be no higher than 20° C, 

QJR- hot water pump temperature up to 100 ° C.

(5)Water and sand content (by mass) of not more than 0.01%.

(6)Water PH 6.5-8.5.

(7)The hydrogen sulfide in water content is not more than 1.5 mg / L.

YQ series submersible water pump motor

YQ------submersible motor

175-----suitable for 175mm(7inch) deep well

200-----suitable for 200mm(8inch) deep well

250-----suitable for 250mm(10inch) deep well

300-----suitable for 300mm(12inch) deep well

400-----suitable for 400mm (16inch) deep well