Upright cylinder spray machine
Technology, equipment performance characteristics
1 main parts and electrical components are imported components, low failure rate, long service life (such as SMC or CKD of Japan, the United States of America, self-locking electromagnetic valve cylinder buffer, Japan NSK bearings, Japan OMRON switch etc.). 2 alternative before and after the fixed-point fixed-point standing erect function, can improve production efficiency, mechanical structure durable. 3 single, but also with the die casting machine, feeding machine, removing machine line, become fully automated equipment. 4 separate of the fixed mold, die spraying time, quantity of spraying and blowing time to adjust, save the coating to improve the quality of castings. 5 up blowing function, can make the cleaning dirt is fixed on the mold surface at the same time after rising, the mold surface is kept clean. 6 adjustable demoulding agent. 7 ascending and descending speed stability, fast declining deceleration function, can prolong the life of the rise and fall of the buffer, adjustable speed. A falling prevention device to prevent the nozzle pressure source stops down. 8 according to the customer demand increase the intermediate spray, using two kinds of release agent to increase the demoulding effect. 9 is provided with a rising side rotates to the die casting machine function, even die flying material phenomenon will not plug nozzle. 10 the Chinese man-machine interface touch screen, can be convenient to set the various parameters, real-time monitoring of machine status and fault diagnosis display, make the operation and maintenance are very convenient. Main configuration: Ø fluid valve - Japan SMC/CKD Ø waterproof gas control valves - Japan SMC/CKD Ø cylinder control solenoid valve - Japan SMC/CKD Ø rotation buffer - Japan SMC/CKD Ø locking cylinder - Japan SMC/CKD Ø rotating cylinder - Japan SMC/CKD Ø elbow rotation - Japan NSK Ø trachea - Taiwan SHSNS Ø silencer - Japan KURODA Ø pressure filter Japan CKD Ø induction switch - Japan - Japan NSK bearing SMC/CKD Ø Ø self-lubricating bearing - Taiwan - Japan PISCO/CKD Ø Ø fast joint pressure joint - Taiwan Ø high-pressure tubing - Taiwan model parameters
1# 2# 3# 4# specifications / model
Application of 125-200T 250-350T 400-500T 630-800T die casting machine
Nozzle form brass ≥ 30PCS ≥ 30PCS ≥ 40PCS brass brass brass ≥ 40PCS
The air pressure source PT1 "6kgf/cm ² 6kgf/cm ² 6kgf/cm ² 6kgf/cm ²
From the type of pipe diameter PT1/2 "PT1/2" PT1/2 "PT1/2"
Mold thickness adjusting range of 150mm 150mm 200mm 250mm
Rise time of 1.0sec 1.0sec 1.5sec 2.2sec
Fall time 1.2sec 1.2sec 1.5sec 2.2sec
Spraying time dynamic / static model time can be adjusted independently
Spraying the amount of dynamic / static die spraying amount can be adjusted separately
