|Origin:||Made In China|
|Category:||Electronics & Electricity / Other Electrical & Electronic|
|Label:||Nemesis , Nemesis e-cig , Nemesis clone|
|Min. Order:||10 set|
|This Co. have total 20 Related Items||Prev11121314151617181920|
Mech Mod Clone Nemesis E-cig
The Nemesis is made in Greece, where form and function have no limits. This mechanical mod is available in Polished, Matte, VW Edition, Kalafan Edition. Main tube on the Nemesis is laser etched and individually serial numbered. Top and bottom contacts are silver plated to reduce voltage loss allowing you to get the most power out of this device.
This mod comes in its own velvet bag with 3 extra extensions and a spare bottom button spring. One short extension made specifically to run a kick in this device. Spare tubes allow this device the ability to use one of three batteries; an 18350, an 18490 or an 18650. To accommodate the 18490 or 18650, you simply attach one of the extension tubes to the 350 tube & voilà. To add a kick, simply attach the short tube.
The bottom button has an exquisite switch, that is easily fired because it sits comfortably in your hand. The bottom locking ring on this device can be tightened all the way down to conceal the battery vent holes when in stealth mode and the top cap ring allows for adjustable air flow. The nicest and newest feature of this device or any mechanical device is the bottom button has its own adjustable post, making it very versatile.
1.Available in Polished, Matte, Kalafan and VaporWall (Two-tone matte SS & polished SS), and Vape Rev Edition (Brass and polished SS) finishes
2.Three tubes for 18350, 18490, and 18650
3.Kick ring for kick or two-tone finish look (If used as two-tone, a long contact post is required)
4.Top cap has an adjustable pin for the atomizer
5.Bottom cap is screwed in to adjust for battery size
6.Adjustable throw on bottom connection. Tighten to shorten throw, loosen to lengthen throw
7.There is a small pin in the bottom switch that prevents the switch from spinning
1.Long contact post- Used when the battery is too short to use with the kick ring
2.Short contact post- Replacement for the stock post
1)Flat caps (Matte and polished)- Eliminates airflow control rings for atomizers that don't have airflow from the bottom. Shortens overall length.
2)Tapered 14mm, 16mm, and 17mm caps for slimmer atomizers