Home > Products > Security & Protection > Alarm

Product name:Mobile Anti-theft Display Stand with Alarm
product information:
This elegant Security and high practical mobile alarm holder , with UV surface treatment technology, which greatly promoted the launching of experiential marketing,it also benefits the product performance and security.

Now it was widely used in various types of mobile phones, cameras, MP4 and other Consumer Electronics products.This product has changed the marketing model of the store.The marketing model upgrade from the traditional "tell" type to the innovative "experiential" type, which allows consumers convenient to choose products and services, but also enhance the enterprise 's performance.

Customers can easily remove the exhibit from the shelf, then operate the function . If somebody want to take away the display, the alarm immediately sounded , alarm sound will continue until the management personnel to do the reset processing.

Security alarm holder for mobile are composed of the host alarm system, multi-touch alarm sensor, 3M adhesive and other components. Simple installation methods, such as installation of alarm installed in display racks or display case, Sensor (alarm probe) adhere to the product.

 Function:
1) Host Base with Charging Function, Charging monthly , Repeated use.
2)Display Charging Function apply to : Mobile Phone , DC camera , Tablet PC
3)Disconnection Alarm Function: Three Contacts disconnection alarm
4)Low Voltage Alarm Function :Voltage Less 3.3V Alarm ,remind the charging
5)Short Circuit Alarm Function : circuit is short-circuited ,automatic alarm
6)Infrared Remote Control Function : Remote Start and Disarm the Alarm.
7)Installation Method : Double ways in 3mm adhesive or use screws tighten.

 Products installation
1.Clean the display case, then turn on switch on the bottom of Security alarm holder for mobile host, adhere the bottom of the anti-theft frame with 3M adhesive tape to the exhibit cabinet. Or use two anti-theft screws to connect the cabinet frame and tighten the exhibition (open f the screw hole cover firstly)
2.Connect the charger of Security alarm holder for mobile with the alarm host, the other end into the power socket in preparation for a fixed monthly charge.
3.Tear off the 3 adhesive tape from the Anti-Theft Terminal product display and paste exhibit’s back fastened
4.Tear off 3M adhesive from the sensor probe, stick tight with the obverse of the product
5.Take out the Infrared remote control board , tear off the battery insulation sheet underneath. Press the ON key , the host switch on ,enter the preset alarm status
6.The installation is set up

 Products list
1,Mobile anti-theft alarm holder/stand host base (with a rechargeable lithium battery inside) 1 pcs.
2, Alarm sensor probe(with a magnetic back, paste 3M adhesive. Extension cords ) 1 set
3, Charger and USB charging cable   1 set
4, Cell phone charging adapter cable 1 pcs
5, Remote control                   1 pcs
6 ,Operation Manual                 1pcs
7 ,Additional 3M adhesive and screws 1 set