sell Quality Curves with Geogrid
Product Description
Inside Curves
Geogrid needs to have 100% coverage around an inside curve. To achieve this, additional layers need to be installed either above or below the course where the grid is required to fill voids that are created.
Cut geogrid to required lengths per the approved plan.
Lay out the primary geogrid around the curve butting front edges together. Make sure strength direction runs perpendicular to wall face. Mark the blocks or take note of the areas where there are voids in the grid placement.
Place the filler piece of grid on the next course (or the course below) to cover the void left on the primary layer.
Outside Curves
Cut geogrid to required lengths per the approved plans.
Lay out the geogrid around the curve.
Lift the section of grid that overlaps and place the fill material to separate. Grid layers need to be separated by a 3 in.
(75 mm) layer of approved fill material.
Never compact directly on the geogrid.
Product Image
Img 1
Img 2
Send Inquiry to this Member
Related Products of this Company
This member assumes full responsibility for the content of this listing. DIYTrade accepts no responsibility whatsoever in respect of such content.
To report fraudulent or illegal content, please
click here.
China Suppliers Quick Searching:
,