Home > Products > Consumer Electronics & Lighting > Lighting > Torch & Flashlight

Product Description

Powerful Primary Underwater Diving Lights/LED Diving Flashlight/LED Canister Torches ARCHON WH46 II/DH40 II

PRODUCT SPECIFICATIONS: 
1. Model: ARCHON WH46 II Canister Diving Light 
2. Bulb: CREE XM-L U2 LED*4 (Max 4800 Lumens) 
3. Color temperature: 6500k. 
4. Three output levels. High> Low>Strobe 
5. Runtime: High: 4.0h, Low: 7.0h, Strobe: 8.0h 
6. Light head: With handheld bracket 
7. Reflector: Glossy Aluminum reflector 
8. Lens: 8mm Polycarbonate Board. 
9. Body material: Durable aircraft-grade aluminum. 
10. Angle of light beam 8° Hot spot, 110° Periphery 
11. Surface treatment: Premium Type III hard-anodizing. 
12. Color: Black 
13. Battery: Rechargeable Li-ion battery pack (26650 battery *8) 
14. Battery Indicator: 100%-50%: Green; 50%-30%: Yellow; 30%-10%: 
Red; Below 10%: Red Flashing; Below 5%: Switch off; 
15. Can be charged directly on the light, with battery over-discharging 
Protection, polarity reversing protection 
16. Fully charging time: 8-10h; 
17. With gas release valve 
18. Operation voltage: 25.2V to 16.8V; 
19. Waterproof: 100 meters underwater 
20. Dimensions: 180mm (canister length)* 60mm (dia. Of canister) * 
64.5mm (dia. Of light head); 
21. Weight: 1890 grams (with battery pack) 
22. Underwater Weight: 950grams (with battery pack) 
23. Impact resistance: 1.5M. 


BATTERY CHARGING 
1. Plug the charger in the wall power socket, the indicator light is green 
In the free-load status. 
2. Open the top cover of the canister, plug the plug of the charger in the 
Ports on the canister. (the positive and negative polar doesn't matter, 
Both ways work. ) 
3. The indicator light is on the charger red if the battery is not fully 
Charged; It will turn green after fully charged. 
4. Take out the charger, put the cover on the canister and use the light. 

ON/OFF 
Push the switch to turn it ON. 

MODES CHANGING 
Successive push the switch ON-OFF within two seconds to cycle through High, Low, strobe, OFF. 

SCUBA DIVING APPLICATION 
Check closely for cuts, scratches, or an otherwise damaged O-ring or mating lens surface as this can cause the light to flood under pressure. Remove any salt deposits, sand, dirt, or other foreign matter from the O-ring sealing surfaces. 
KEEP THE THREADS, O-RING GROOVE LUBRICATED WITH SILICONE GREASE.