Model:E-8

MIC INPUT(XLR)

Connect Microphones here.If you are using a condenser mic,ensure phantom power is supplied by pressing the seitch at the top of the master section(Warning:DO not apply phantom Power before connecting a microphone)

LINE INPUT(1/4”Jack)

Connect Line level sources here,e.g.Synth,Drum Machine,Dletc

INSERT POINT(1/4” jack)

Connect signal processors here,e.g. Compressor,Gate etc

GAIN CONTROL

Adjust these to increase or decrease the level of the incoming signal

EQ STAGE

Adjust these controls to change the signal tone(the character of the signal)

AUX SENDS

Adjust these controls to change the level of the signal to an FX unit or an artist's monitors(headphones /in-ear/stage monitors).Aux1&2 are switchable pre/post fade

PAN CONTROL

Use this control to position the signal within the stereo field

MUTE SWITCH

When this is pressed ou will hear no signal from the channel(post-mute signals)

SOLO

When pressed the signal will appear on the monitor outputs-use this to montior the post EQ signal from the channel

PEAK LED

This is used to indicate that the signal close to distorting(clipping )on a specific channel

INPUT CHANNEL FADER

This is used to control the level fed to the Mix Bus and post-fade sends

MIX OUTPUTS(XLR)

Connect these to your analogue recording device,or to your amplification system

MIX INSERTS(1/4”jack)

This is a pre-fade break in the signal path which can be used to feed ad dynamics or mastering device.The dignal is sent from the tip of the jack plug and the return path comes back in on the ring of the jack plug

MONITOR O/Ps(1/4”jack)

These are used to feed your monitoring system.This can be directly connected to powered monitors ,or indirectly via an amplifier to standard monitors

MASTER FADERS

These faders control the overall level of the mixbus

MAIN METERS

These show the lebel of the mix outputs.When the SOLO LED is lit,the meters show the level of the signal sourced

MONITOR CONTROL

This controls the level of the signal sent to your monitoring systern

PHONES CONTROL

This controls the level of the signal sengt to the headphones jack socket

AUX OUTPUTS(1/4”Jack)

These two outputs can be used to send the channel signal to an FX unit or an artist's montiors(headphones/in-ear/stage monitors).Aux 1&2 are switchable pre/post fade

AUX CONTROLS

These two switches globally switch the AUX1 and AUX2 feeds respectively,on all the input modules to be either pre or post-fade

STEREO INPUTS(1/4”Jack)

These two inputs can be used to connect line level stereo inputs from keyboards,sound modules,samplers,computer based audion cards etc.These inputs pass through a normal channel strip,with EQ Auxes and a Balance control

PLAYBACK INPUTS(RCA PHOTO)

Here ou can connect the playback from your recording device

PLAYBACK CONTROLS

Use these to control the playback signal.The Monitor PLAYBACK switch sends the signal to the monitor outputs and phones,whilst the PLAYBACK TO MIX switch sends it to the main mix

RECORD OUTPUTS

Here you can connect the input to your recording device

PHANTOM POWER

Press thies to switch the phantom power(48V)on for condenser microphones

WARning:Do not apply Phantom Power before connecting a microphone

HEADPHONES(1/4”Jack)

Plug your headphones into theis socket